Exchange reactions isotope effect

Isotope Exchange Reactions In isotope exchange reactions, isotopes of the same elements having different mass numbers replace one or more atoms in a molecule. Examples are labelling of iodide-containing material with iodine radioisotopes. Since the radiolabeled and parent molecules are identical except for the isotope effect, they are expected to have the same biological and chemical properties. 

Most of the chemical properties of tritium are common to those of the other hydrogen isotopes. However, notable deviations in chemical behavior result from isotope effects and from enhanced reaction kinetics induced by the ( -emission in tritium systems. Isotope exchange between tritium and other hydrogen isotopes is an interesting manifestation of the special chemical properties of tritium. 

For the exchanges carried out in liquid ammonia, kinetic isotope effects kD kT of 2.3-2.5 have been obtained for reaction of benzene, toluene, and naphthalene and for the reactions of the 2 positions of furan and thiophene with -butoxide in dimethyl sulphoxide somewhat lower values, 1.5 and 1.3, respectively, were obtained591, but whether this was a solvent or a substituent effect is not apparent from the data. 

One further approach, which has not properly been explored, is based upon the axiom of Harbottle s (29) that if an isotopic difference is found, there must have been little reaction subsequent to the initial hot stage. That is, these subsequent reactions are expected to be normal chemical reactions with essentially no isotopic preference, such that any such reaction would tend to wash out possible isotope effects. This problem is worth pursuing further, since some isotopic effects have been observed where subsequent exchange is to be expected. 

Eichler and Wahl have attempted an isotopic study ( Os and Os) of the exchange reaction between Os(dipy)3 and Os(dipy)3 using a direct injection technique so that reaction times 7 x 10 sec were possible. With total osmium 10" M in aqueous sulphate media at 0 °C complete exchange was observed. The separation methods used were, (a) perchlorate precipitation (in presence of iron(II) carrier) and (6) extraction with p-toluenesulphonic acid in nitromethane, of the osmium(II) complex. A lower limit of 1 x 10 l.mole. sec was placed on the rate coefficient (0 °C, 3.0 M H2SO4). Dietrich and Wahl using the line broadening effect produced by Os(dipy)3 on the nmr spectrum of Os(dipy)3 have been able to propose a value of > 5x 10" l.mole . sec at 6 °C in D2O (0.14 M [Cr] and 5x10 M [D- ]). 

Although the radioactive isotope H has been extensively used for studies on the uptake of xenobiotics into whole cells, the intrusion of exchange reactions and the large isotope effect renders this isotope rather less straightforward for metabolic studies. Both deuterium H-labeled substrates, and oxygen and OH2 have, however, been extensively used in metabolic studies, since essentially pure labeled compounds are readily available and mass spectrometer facilities have become an essential part of structural determination. 

At Bayer CropScience, the use of a stable isotope IS has become common practice to eliminate the effects of matrix suppression on instrument signals. The stable isotopes are synthesized by deuterium exchange reactions on authentic native standards or the... 

This is the same mechanism as that given above for esters, in equation (42). The difference between esters and amides is apparent from a comparison of the two tetrahedral intermediates [5] and [17], The former contains three oxygens, any of which can be protonated, resulting in much lsO exchange being observed when the reaction takes place in 180-enriched water,275,276 but [17] contains a much more basic nitrogen, which will be protonated preferentially and lead to much less 180 exchange, as observed.274 277,278 Also, ammonium ion formation makes the overall reaction irreversible, unlike ester hydrolysis. The calculated solvent isotope effect for the Scheme 15 process is 1.00,280 exactly in accord with experimental observation.278,279... 

The observation of a primary solvent deuterium isotope effect (kH/fa>) = 2-4 on the specific acid-catalyzed hydrolysis of vinyl ethers provides evidence for reaction by rate-determining protonation of the alkene.69 Values of kHikD 1 are expected if alkene hydration proceeds by rate-determining addition of solvent to an oxocarbenium ion intermediate, since there is no motion of a solvent hydron at the transition state for this step. However, in the latter case, determination of the solvent isotope effect on the reaction of the fully protonated substrate is complicated by the competing exchange of deuterium from solvent into substrate (see above). 

S-ionol 1,2-reduction, 130-131 Kinetic isotope effects, silicon exchange reactions, 8-9... 

The absence of an isotope effect when the reaction was carried out in benzene suggested to the authors that no significant change in bonding occurred to the -H, the hydroxyl H or the carboxyl H in the rate-determining step of the reaction. Hence they proposed that Pb(OAc)4 undergoes rapid anion exchange with mandelic acid in the non-polar medium... 

Evaluation of kinetic data. Rate constants were determined for 2-H exchange from 3-R-4-methylthiazolium ions, catalyzed by D2O (pseudo first order) and DO- (second order).154 The observed rate constants for the pD-independent exchange reaction were corrected for the solvent isotope effect ( h2o/ d2o = 2.6), and the reverse protonation of the carbene by H30+ was assumed to be diffusion-controlled (k = 2 x 1010 M-1 s-1). A similar analysis was performed for the exchange catalysed by DO-. The results agreed nicely, giving pAfa = 18.9 for 213 and p/sfa = 18.0 for thiamine.154 The thiazolium ion 213 seems to be less acidic in water154 than in DMSO152 (Ap/fa = 2.4). Aside from the... 

---