Equilibrium elasticity modulus

To determine the crosslinking density from the equilibrium elastic modulus, Eq. (3.5) or some of its modifications are used. For example, this analysis has been performed for the PA Am-based hydrogels, both neutral [18] and polyelectrolyte [19,22,42,120,121]. For gels obtained by free-radical copolymerization, the network densities determined experimentally have been correlated with values calculated from the initial concentration of crosslinker. Figure 1 shows that the experimental molecular weight between crosslinks considerably exceeds the expected value in a wide range of monomer and crosslinker concentrations. These results as well as other data [19, 22, 42] point to various imperfections of the PAAm network structure. 

Ronca and Allegra (12) and Flory ( 1, 2) assume explicitly in their new rubber elasticity theory that trapped entanglements make no contribution to the equilibrium elastic modulus. It is proposed that chain entangling merely serves to suppress junction fluctuations at small deformations, thereby making the network deform affinely at small deformations. This means that the limiting value of the front factor is one for complete suppression of junction fluctuations. 

This is a theoretical study on the structure and modulus of a composite polymeric network formed by two intermeshing co-continuous networks of different chemistry, which interact on a molecular level. The rigidity of this elastomer is assumed to increase with the number density of chemical crosslinks and trapped entanglements in the system. The latter quantity is estimated from the relative concentration of the individual components and their ability to entangle in the unmixed state. The equilibrium elasticity modulus is then calculated for both the cases of a simultaneous and sequential interpenetrating polymer network. 

Among them is the gel point conversion, if multifunctional units are present, as well as accompanying divergence of viscosity, onset of equilibrium elasticity modulus, etc. By comparing the results of modeling with experiment, one can verify to what extent the chemistry is affected by physical interactions which are practically always active in polymerizations. 

EXPERIMENTAL RESULTS, 604 Equilibrium Elastic Modulus, 604 Dynamic Elastic Modulus, 608 Loss Modulus, 608 Ultimate Properties, 611... 

The estimate for the equilibrium elasticity modulus at room temperature is then G, w 3 x 10 -4 x 10 " = 1.2 X lO dyn/cm, which agrees weU with the order of magnitude of the experimentally determined value of 1.25 x 10 dyn/cm. This agreement suggests that the proposed views on the mechanism of the reversible deformations are valid. 

Temperature dependencies of loss modulus G" and tan S usually show sharp maxima at the glass transition temperatures that correspond to the cooperative movement of the segments of polymer chains. Low-temperature maxima are ascribed to the movements of short fragments of the main chain or of the side groups. The equilibrium elastic modulus oo could be an important characteristic of the cross-linking density in IPNs and may be presented as consisting of two parts ... 

---