Equation oriented simulation mode

The older modular simulation mode, on the other hand, is more common in commerical applications. Here process equations are organized within their particular unit operation. Solution methods that apply to a particular unit operation solve the unit model and pass the resulting stream information to the next unit. Thus, the unit operation represents a procedure or module in the overall flowsheet calculation. These calculations continue from unit to unit, with recycle streams in the process updated and converged with new unit information. Consequently, the flow of information in the simulation systems is often analogous to the flow of material in the actual process. Unlike equation-oriented simulators, modular simulators solve smaller sets of equations, and the solution procedure can be tailored for the particular unit operation. However, because the equations are embedded within procedures, it becomes difficult to provide problem specifications where the information flow does not parallel that of the flowsheet. The earliest modular simulators (the sequential modular type) accommodated these specifications, as well as complex recycle loops, through inefficient iterative procedures. The more recent simultaneous modular simulators now have efficient convergence capabilities for handling multiple recycles and nonconventional problem specifications in a coordinated manner. 

Flowsheeting is still dominated by the Sequential-Modular architecture, but incorporates increasingly features of the Equation-Oriented solution mode. A limited number of systems can offer both steady state and dynamic flowsheeting simulators. 

When there are multiple recycles present, it is sometimes more effective to solve the model in a simultaneous (equation-oriented) mode rather than in a sequential modular mode. If the simulation problem allows simultaneous solution of the equation set, this can be attempted. If the process is known to contain many recycles, then the designer should anticipate convergence problems and should select a process simulation program that can be run in a simultaneous mode. 

---