Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Electromagnetic interferences

ALKALI AND CHLORINE PRODUCTS - CHLORINE AND SODIUM HYDROXIDE] (Vol 1) Electromagnetic interference... [Pg.356]

Environmental factors such as temperature, humidity, moisture, and Electromagnetic Interference (EMI) or Radio Frequency Interference (RFI) can affect performance if insufficient care is exercised in designing the scale... [Pg.327]

The twists of twisted pair cable act as a shield against radio frequency interference (REI), and electromagnetic interference (EMI), and against the cross talk interference that a wire exerts on nearby wires the more twist the less interference. Telephone wires can use large numbers of pairs. In most cases the pairs are not shielded with braiding or foil, as shown in Eigure lb for data communication wire. Data communication wires work at very high... [Pg.322]

Electromagnetic interference (EMI) testing has become more prevalent for materials that either emit or are affected by EMI. Shielding efficiency (SE) of materials is deterrnined by measuring electric field strength between a transmitter and receiver with or without the presence of the material under test. Several researchers have suggested a correlation between volume resistivity and SE values (300,301). [Pg.155]

Also, the electronic control-valve device s level of immunity to, and emission of, electromagnetic interference (EMI) can be an issue in the chemical-valve environment. EMI requirements for the control-valve devices are presently mandatory in the European Community but voluntary in the United States, Japan, and the rest of the world. International Electrotechnical Commission (lEC) SOI, Parts I through 4, Electromagnetic Compatibihty for Industrial Process Measurement and Control Equipment, defines tests and requirements for control-device immunity. Immunity and emission standards are addressed in CENELEC (European Committee for Electrotechnical Standardization) EN 50 081-1 1992, EN 50 081-2 1993, EN 50 082-1 1992, and prEN 50 082-2 1994. [Pg.786]

Protect against electromagnetic interference (EMI), electrical interference and radio frequency interference (REI)... [Pg.118]

What safety and radio frequency interference and electromagnetic interference (RFI/EMI) regulations must the system meet to be able to be sold into the target market This would affect not only the electrical design but also the physical design. [Pg.2]

RFIIEMI (Radiofrequency and electromagnetic interference) which regulatory agency specifications the product must meet. [Pg.7]

The spatial resolution of the CI SEM mode depends mainly on the electron-probe size, the size of the excitation volume, which is related to the electron-beam penetration range in the material (see the articles on SEM and EPMA), and the minority carrier diffusion. The spatial resolution also may be afiFected by the signal-to-noise ratio, mechanical vibrations, and electromagnetic interference. In practice, the spatial resolution is determined basically by the size of the excitation volume, and will be between about 0.1 and 1 pm ... [Pg.153]

Electromagnetic Interference (EMI) Electromagnetic energy that causes interference in the operation of electronic equipment. Can be conducted, coupled or radiated. Can be natural or man-made. [Pg.613]

Electromagnetic interference Interference created by rotating electrical equipment causing problems in areas such as microelectronics clean rooms. [Pg.1433]

Instruments with a balanced input circuit are available for measurements where both input terminals are normally at a potential other than earth. Further problems arise due to common-mode interference arising from the presence of multiple earth loops in the circuits. In these cases the instrument may need to be isolated from the mains earth. Finally, high-frequency instruments, unless properly screened, may be subject to radiated electromagnetic interference arising from strong external fields. [Pg.239]

See other pages where Electromagnetic interferences is mentioned: [Pg.38]    [Pg.40]    [Pg.356]    [Pg.360]    [Pg.290]    [Pg.291]    [Pg.339]    [Pg.195]    [Pg.196]    [Pg.457]    [Pg.392]    [Pg.162]    [Pg.553]    [Pg.335]    [Pg.115]    [Pg.339]    [Pg.93]    [Pg.96]    [Pg.241]    [Pg.242]    [Pg.243]    [Pg.244]    [Pg.245]    [Pg.246]    [Pg.247]    [Pg.248]    [Pg.249]    [Pg.160]    [Pg.299]    [Pg.278]    [Pg.278]    [Pg.383]    [Pg.650]   
See also in sourсe #XX -- [ Pg.14 , Pg.54 ]

See also in sourсe #XX -- [ Pg.21 ]

See also in sourсe #XX -- [ Pg.51 ]

See also in sourсe #XX -- [ Pg.171 ]

See also in sourсe #XX -- [ Pg.11 ]

See also in sourсe #XX -- [ Pg.155 ]

See also in sourсe #XX -- [ Pg.399 ]

See also in sourсe #XX -- [ Pg.450 ]

See also in sourсe #XX -- [ Pg.132 ]

See also in sourсe #XX -- [ Pg.79 , Pg.80 , Pg.88 , Pg.89 , Pg.90 ]

See also in sourсe #XX -- [ Pg.26 , Pg.451 , Pg.452 , Pg.470 , Pg.472 , Pg.473 , Pg.476 , Pg.478 , Pg.482 , Pg.483 , Pg.484 , Pg.485 , Pg.486 , Pg.492 , Pg.493 , Pg.496 , Pg.497 , Pg.499 , Pg.504 , Pg.505 , Pg.507 , Pg.508 ]

See also in sourсe #XX -- [ Pg.71 ]

See also in sourсe #XX -- [ Pg.152 ]

See also in sourсe #XX -- [ Pg.132 ]

See also in sourсe #XX -- [ Pg.108 , Pg.155 ]

See also in sourсe #XX -- [ Pg.203 ]

See also in sourсe #XX -- [ Pg.210 ]

See also in sourсe #XX -- [ Pg.595 ]

See also in sourсe #XX -- [ Pg.225 ]

See also in sourсe #XX -- [ Pg.22 ]

See also in sourсe #XX -- [ Pg.242 ]

See also in sourсe #XX -- [ Pg.2 , Pg.5 , Pg.7 , Pg.127 ]

See also in sourсe #XX -- [ Pg.113 ]

See also in sourсe #XX -- [ Pg.210 ]

See also in sourсe #XX -- [ Pg.937 ]



SEARCH



Electromagnet interference

© 2024 chempedia.info