Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Electrochemical potentiodynamic reactivation

Electrochemical potentiodynamic reactivation (EPR) is another polarization method that evaluates the degree of sensitization of stainless steels such as S30400 and S30403 steels. This method uses a potentiodynamic sweep over a range of potentials from passive to active (called reactivation). [Pg.109]

Lopez, N., Cid, M., Puiggali, M. et al. (1997) Application of double loop electrochemical potentiodynamic reactivation test to austenitic and duplex stainless steels. Mater. Sci. Eng, A229(l), 123—128. [Pg.448]

The research on corrosion, started in this institute in the 1950s, continued successfully further. The intergranular corrosion of steels was measured by an electrochemical potentiodynamic reactivation method [310-312]. Since the 1960s, the passivity of brass was further studied, the rates of corrosion were measured by polarization resistance, the effect of deformation on anodic dissolution of steels was followed, and the surface roughness of metals was measured other subjects of research were, e.g., the behavior of passive films on steel, the effect of compositirai and motion of electrolyte on corrosion of passivated aluminum, the cathodic protection of passive metals against corrosion, the anodes for cathodic protection of steels, etc.[313-316]. Measurements of polarization resistance in the system iron—concentrated sulfuric acid or boiling nitric acid, of corrosion and matter... [Pg.27]

Potentiodynamic gas sensors have a schematic structure that is practically equal to that of amperometric gas sensors. They are -> electrochemical cells that measure a -> current signal directly related to the concentration of the analyte, but are not necessary operated in a region where -> mass transport is limiting. They are typically employed to detect less reactive species such as benzene and halogenated hydrocarbons that require a previous accumulation step at a suitable -> adsorption potential to be then reduced or oxidized according to a given potential scan [iii]. The adsorption time can be automat-... [Pg.294]


See other pages where Electrochemical potentiodynamic reactivation is mentioned: [Pg.528]    [Pg.528]    [Pg.487]    [Pg.280]    [Pg.378]    [Pg.152]    [Pg.1]    [Pg.32]    [Pg.124]    [Pg.180]    [Pg.140]   
See also in sourсe #XX -- [ Pg.109 ]




SEARCH



Electrochemical potentiodynamic

Electrochemical reactivity

Potentiodynamic

Potentiodynamics

© 2024 chempedia.info