Electric motors direct current

Power Take-Off From Engine or Transmission. This type of system is limited to tmcks and there are several take-off means available. Most are some form of electric power generation equipment, belt-driven from the engine crankshaft, which produces either a regulated a-c voltage or rectified direct current for the compressor and fan motors in the body. 

The centrifugal pump directly driven by a variable-speed electric motor is the most commonly used hardware comoination for adjustable speed pumping. The motor is operated by an electronic-motor speed controller whose function is to generate the voltage or current waveform required by the motor to make the speed of the motor track the input command input signal from the process controller. 

The electrical power supplied to electrical motors can be from a direct-current (dc) source or an alternating-current (ac) source. Because dc motors are more... 

Italian-American physicist Nikola Tesla invents a motor that produces alternating current. This discovery changes the way electricity is transmitted over long distances. The first commercial, long-distance transmission of electricity takes place when a direct-current line provides power from Willamette Falls for street lights in Portland, Oregon. 

This is a very good motor for direct connection to certain loads, particularly where constant speed is required. NEMA defines it as a synchronous machine which transforms electrical power from an alternating-current system into mechanical power. It usually has direct-current field excitation by a separately driven direct-current generator or one directly connected to the motor. This motor remains synchronous with the supply frequency and is not affected by the load. Proper application requires consideration of the following ... 

The running speed of electric motors, both alternating current (AC) and direct current (DC), varies. Therefore, for monitoring purposes, these motors should be classified as variable-speed machines. A narrowband window should be established to track the true running speed. 

Although at the time of his early inventions Dr. Schoop envisaged that an electric arc could be used to produce the molten metal for spraying, forty years passed before the method became commercially important. Then, in Germany, Russia and Japan tools were made based on the arc. Although in Japan alternating current is used, the noise is nearly intolerable and elsewhere direct current from motor generators is employed. The fundamental idea is simple two wires, carefully insulated from each other, are advanced to meet at a point where an arc is formed, immediately in advance of a Jet... 

The tip is first brought near to the sample via a coarse Z positioner, such as a controlled approach piezo-electric motor. This provides a 10 A step size and so is capable of very precise and controlled movement. As soon as a tunnelling current is detected, the tip is stopped and the fine control system is operated. Thus the lip is mounted on the end of a hollow, cylindrical piezo crystal, a tube scanner (a piezo-electric crystal can be made to deform under the influence of a voltage applied across it). The tube scanner has four strip electrodes on the outside, providing movement in the x and y directions (lateral movement), and one electrode covering the whole of the inside. A... 

A steam turbine is a machine with an ancient genealogy. It is a direct descendant of the overshot water wheel, used to kick off the industrial revolution in England, and the windmill still used in Portugal. Turbines are widely used in process plants to drive everything from 2-hp pumps to 20,000-hp centrifugal compressors. They are versatile machines, in that they are intrinsically variable-speed devices. Electric motors are intrinsically fixed-speed machines. It is true that there are a variety of ways to convert AC (alternating-current) motors to variable speed, but they are all expensive and complex. 

It is noteworthy for people busy in the field of electrical power engineering that ohmic-inductive circuits with L/R ratios <1 ms (even in the range L/R = 10 ps or L/R = 100 ps) are considered as inductive circuits in EN 50020. For comparison, in power circuits, contactors and motor starters for direct current application are rated for L/R ratios within a range 1 ms = L/R 15 ms... 

---