Electric motor armatures

Electric motors. Vibration behaves like unbalance Electric motor armature High eccentricity... 

Machined deposits on new equipment, including undercoats for chromium, are usually 125-500 im thick. Applications include cylinder liners (on the water side), cylinders used in the rubber, pulp and paper handling industries, compressor rods and armatures for electric motors. 

One would draw it out by making it drive a current through an external load (e.g., the armature of an electric motor), which ideally would convert the electrical energy to mechanical energy at 100% efficiency and which in fact does carry out such a conversion at more than 95% efficiency. 

ARMATURE - the rotating part of an electric motor or generator. The moving part of a relay or vibrator. 

In a simple electric motor, like the one shown in Fig. 2, a piece of iron with loops of wire round it, called an armature, is placed between the north and south poles of a stationary magnet, known as the field magnet. When electricity flows around the armature wire, the iron becomes an electromagnet. 

Since the power loss in the bearing of the circular pendulum mixer in the measuring kettle is guaranteed to remain imchanged during measurement and electric motors without armature retroaction, i.e. DC disk-armature motors are used, relationship (2.7) holds between the total motor power Pm2 and the mixing power psa- Therefore, the following expression results ... 

Constant-speed motors are usually suited for a speed range of less than 3 to 1 by field control, but mechanical and electrical characteristics govern maximum safe speeds. With constant voltage on the armature, as the field is weakened the speed increases and the motor develops constant horsepower. 

The field and armature windings are connected in series and consequently share the same current. The series motor has the characteristics of a high starting torque but a speed which varies with load. Figure 2.47 shows series motor connections and characteristics. For this reason the motor is only suitable for direct coupling to a load, except in very small motors, such as vacuum cleaners and hand drills, and is ideally suited for applications where the machine must start on load, such as electric trains, cranes and hoists. 

The VOM is the best all-around electronic instrument for industrial plant maintenance. Various electrical tests can be made on rotating electrical equipment, such as motors and generators, to check all operating conditions. For example, to check continuity of shunt field and armature coils. 

---