Electric furnace power distribution

Power Supplies and Controls. Induction heating furnace loads rarely can be connected directiy to the user s electric power distribution system. If the load is to operate at the supply frequency, a transformer is used to provide the proper load voltage as weU as isolation from the supply system. Adjustment of the load voltage can be achieved by means of a tapped transformer or by use of a solid-state switch. The low power factor of an induction load can be corrected by installing a capacitor bank in the primary or secondary circuit. 

Fig. 4.2. Waste heat boiler for a copper smelting flash furnace (Peippo et al, 1999). Note, left to right (i) flash furnace gas offtake (ii) boiler radiation section with water tubes in walls (iii) suspended water tube baffles in radiation section to evenly distribute gas flow (iv) convection section with hanging water tubes. Steam from the boiler is used to generate electricity, to power the acid plant s main blower and for general heating and drying.

---