Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Edge rounding

Nominal inside pipe diameter, in Maximum diameter of pressure tap, mm (in) Radius of hole-edge rounding, mm (in)... [Pg.885]

The discharge coefficient of sharp-edged orifices was shown by Benedict, Wyler, and Brandt [J. Eng. Fower, 97, 576-582 (1975)] to increase with edge roundness. Typical as-purchased orifice plates may exhibit deviations on the order of 1 to 2 percent from ASME values of the discharge coefficient. [Pg.894]

DEPRESSOR TONGUE 6X0,75X0 0675" PARALLEL EDGES ROUNDED ENDS 100S 6515013055120 PG 275 ... [Pg.407]

Extemalforms rounded corners and edges rounded faces rounded Ml, hkO faces... [Pg.176]

Fig. 7.21 Influence of edge rounding radius on the secondary current density distribution along the surface of plate electrode (parameter x) between location a and b (kinetics obtained from regional tap water study, cti = 47 ppm, average current load —50 A m 2 calculated cell voltage for all radius nearly constant value of 6.04 V, electrolyte conductivity 667 p,S cm-1). Fig. 7.21 Influence of edge rounding radius on the secondary current density distribution along the surface of plate electrode (parameter x) between location a and b (kinetics obtained from regional tap water study, cti = 47 ppm, average current load —50 A m 2 calculated cell voltage for all radius nearly constant value of 6.04 V, electrolyte conductivity 667 p,S cm-1).
The edge-based maxima in Fig. 7.21 demonstrate how these places may function at a clearly higher current density (and by-product formation) compared with the average current density. Thus, edge rounding is a sophisticated method of lowering the risk. [Pg.194]

Seats should be padded, covered with non-slip materials and have front edge rounded... [Pg.1140]

Cutting Edge Geometry, Fig. 2 Tool life map for varying cutting edge roundings... [Pg.296]

Cutting Edge Geometry, Fig. 3 Tool wear mechanisms for changing cutting edge rounding... [Pg.297]

Besides the cutting edge rounding, also chamfer geometries have a high impact on the machining process. Chamfers can be applied at the rake face... [Pg.298]


See other pages where Edge rounding is mentioned: [Pg.10]    [Pg.115]    [Pg.497]    [Pg.234]    [Pg.166]    [Pg.132]    [Pg.835]    [Pg.836]    [Pg.836]    [Pg.839]    [Pg.273]    [Pg.1043]    [Pg.166]    [Pg.1046]    [Pg.835]    [Pg.836]    [Pg.836]    [Pg.839]    [Pg.211]    [Pg.240]    [Pg.242]    [Pg.295]    [Pg.295]    [Pg.295]    [Pg.295]    [Pg.297]    [Pg.298]    [Pg.298]    [Pg.372]   
See also in sourсe #XX -- [ Pg.647 ]




SEARCH



Rounding

Roundness

© 2024 chempedia.info