Strength, dry

Papermaking additives can be categorized either as process additives or as functional additives. Process additives are materials that improve the operation of the paper machine, such as retention and drainage aids, biocides, dispersants, and defoamers they are primarily added at the wet end of the paper machine. Functional additives are materials that enhance or alter specific properties of the paper product, such as fillers (qv), sizing agents, dyes, optical brighteners, and wet- and dry-strength additives they may be added internally or to the surface of the sheet. 

Combinations of anionic and cationic resins are used. Some of the eady systems involved the use of a cationic wet-strength resin with an anionic dry-strength additive to provide both increased wet and dry strength (63). Combinations of anionic and cationic dry-strength additives also are used to provide strength effects which cannot be achieved by using either polymer alone (64). The ratio of the two polymers must be optimized to achieve maximum performance (see Acrylamide polymers). 

Amino resins are used by the paper industry in large volume for a variety of apphcations. The resins are divided into two classes according to the mode of appHcation. Resins added to the fiber slurry before the sheet is formed are called wet-end additives and are used to improve wet and dry strength and stiffness. Resins appHed to the surface of formed paper or board, almost invariably together with other additives, are used to improve the water resistance of coatings, the sag resistance in ceiling tiles, and the scuff resistance in cartons and labels. 

This reduces pulp tensile strength but improves tear strength not because of fiber degradation but because the hemiceUuloses bond chemically to give added tensile strength in the final paper product. To overcome this loss in hemiceUulose polymers, starch is added on the wet end of the paper machine as a dry strength additive. 

Recycled paper contains more fines, short fibers, and anionic trash. This will increase demand for process chemicals such as drainage aids and both wet- and dry-strength additives (43). 

In addition to the natural protein fibres wool and silk, fibres have been produced commercially from other proteins. These materials were introduced as wool substitutes but today have little or no significance. Mention may, however, be made of ArdiP products from the groundnut protein and marketed for some years after World War II by ICI. Compared with wool it had inferior wet and dry strength and abrasion resistance. The inclusion of up to 20% ArdiP into wool, however, yielded a product with negligible loss in wearing properties. 

Ayers, P., Development of dry strength in pellets made with soluble salt binders, Inst. Min. Metall., Trans. 85, C177 (1976). 

---