Displacement-Type Level Detectors

The standard ranges of displacement level transmitters are from 36 to 150 cm (14 to 60 in.), whereas special units are available up to 18 m (60 ft). Their error 

---

When detecting the interface between two liquids, electrical conductivity, thermal conductivity, opacity, or sonic transmittance of the liquids can be used. Interface-level switches are usually of the sonic, optical, capacitance, displacer, conductivity, thermal, microwave, or radiation types. Differential pressure transmitters can continuously detect the interface, but, if their density differential is small relative to the span, the error will be high. On clean services, float- and displacer-type sensors can also be used as interface-level detectors. In specialized cases, such as the continuous detection of the interface between the ash and coal layers in fluidized bed combustion chambers, the best choice is to use the nuclear radiation sensors. 

In the pneumatic pumping system, the pressure (and not the flow rate) is maintained constant as variations in chromatographic conditions occur. Thus, a change in mobile phase viscosity (e.g. gradient elution) or column back pressure will result in a change in flow rate for these types of pumps. The gas displacement pump in which a solvent is delivered to the column by gas pressure is an example of such a pneumatic pump. The gas displacement system is among the least expensive pumps available and is found in several low cost instruments. While the pump is nonpulsating and hence, produces low noise levels with the detectors in current use, its flow stability and reproducibility are only adequate. In addition, its upper pressure limit is only 2000 psi which may be too low in certain applications. 

---