Dipole moment dimers

C3.4.13)). The dimer has a common ground state and excitation may temrinate in eitlier tire or excited state (see tire solid arrows in figure C3.4.3). The transition dipole moments of tliese transitions are defined as ... 

Figure C3.4.4. Definition of the dimer transition dipole moments and p on tire basis of tire monomer transition dipole moments p and P2-...

Experimental values are collected in the McClellan book (B-63MI40400) and in a review on dipole moments and structure of azoles (71KGS867). Some selected values are reported in Table 3. The old controversy about the dipole moment of pyrazole in solution has been settled by studying its permittivity over a large range of concentrations (75BSF1675). These measurements show that pyrazole forms non-polar cyclic dimers (39) when concentration increases and, in consequence, the permittivity value decreases. 

Acetanilide, electrophilic aromatic substitution of, 939-940 Acetate ion, bond lengths in, 43 electrostatic potential map of, 43, 53, 56, 757 resonance in, 43 Acetk acid, bond angles in, 755 bond lengths in, 755 dimer of, 755 dipole moment of, 39 electrostatic potential map of, 53, 55... 

For large interchain separations (8 A < R < 30 A), the LCAO coefficients of a given molecular orbital are localized on a single chain, as intuitively expected. The lowest excited state of these dimers results from a destructive interaction of the two intrachain transition dipole moments, whereas a constructive interaction prevails for the second excited stale. This result is fully consistent with the molcc-... 

Table 6-3. Comparison of the dipoles of the isolated individual monomers (dipole M) compare to the dipole moments of molecules within the dimer (dipole D) via the interaction, calculated with different functionals. Units are atomic units, and we give as well the difference in length and orientation ...

Figure 6-2. ELF moments for the canonical water dimer (dipole moments in Debye, Mi in au.)...

Dimers (73) and (74) were formed in approximately equal amounts in all cases, although, as in the cases of 2-cyclopentenone and 2-cyclohexenone, the relative amount of (72) (either cis-syn-cis or cis-anti-cis) was found to vary substantially with solvent polarity. As in 2-cyclopentenone, this increase in the rate of head-to-head dimerization was attributed to stabilization of the increase in dipole moment in going to the transition state leading to (72) in polar solvents. It is thought that the solvent effect in this case is not associated with the state of aggregation since a plot of Stem-Volmer plot and complete quenching with 0.2 M piperylene indicate that the reaction proceeds mainly from the triplet manifold. However, the rates of formation of head-to-head and head-to-tail dimers do not show the same relationship when sensitized by benzophenone as in the direct photolysis. This effect, when combined with different intercepts for head-to-head and head-to-tail dimerizations quenched by piperylene in the Stem-Volmer plot, indicates that two distinct excited triplet states are involved with differing efficiencies of population. The nature of these two triplets has not been disclosed. 

The structure of the dimers from mero-substituted derivatives was initially determined by comparison of the observed and calculated dipole moments. For a head-to-tail dimer the dipole moments resulting from the 9 and 9 substituents should cancel each other and the resultant dipole moment should be essentially zero. For a head-to-head arrangement the dipoles would be in the same direction and the resultant should be considerably greater than zero. The dimers produced upon irradiation of 9-chloro and 9-bromoanthracene solutions were observed to be 0.36 and 0.60 D, respectively. Since these values are much less than expected for a head-to-head arrangement for these derivatives (3.8 D), it was concluded that both of these dimers were formed in a head-to-tail configuration/30 ... 

Hobza, P., H. L. Selzle, and E. W. Schlag. 1990. Floppy Structure of the Benzene Dimer Ab Initio Calculation on the Structure and Dipole Moment. ... 

Table 4.3. Water dimer properties the interaction energy (Ei t) in kcal/mol, the intermolecular distance (R00) in A, and the dipole moment p. in Debye, calculated using the B88/P86 exchange-correlation functional and different basis sets.

Typical examples are the conversion of the neutral form of an amino acid into its zwitterionic form, the helix-coil transitions in polypeptides and polynucleotides, and other conformational changes in biopolymers. Reactions of higher molecularity in which reactants and products have different dipole moments are subject to the same effect (association of the carboxylic acids to form hydrogen-bonded dimers). Equilibrium involving ions are often more sensitive to the application of an electric field ... 

The Anisotropy Between the Transition Dipole Moments of the Chromophores in the Dimer Model... 

---