Laser solid state, diode-pumped

Fig. 5.5 Experimental setup. The diode laser is frequency scanned by one waveform generator, while the other controls the modulation. The light couples from a tapered fiber into and back out of microsphere WGMs, and the throughput is detected. A polarizing beamsplitter (PBS) separates throughput of the two polarizations. A diode pumped solid state laser can be used as an external heat source for the microsphere, and the vacuum chamber allows control over the ambient pressure. Reprinted from Ref. 5 with permission. 2008 International Society for Optical Engineering...

Femtosecond Ti-Sapphire oscillator (CDP, TiF50, 100 fs, 80 MHz, 0.3 W, 800 run) pumped with diode pumped solid state laser (Coherent, Verdi) was used to excite the system. The time- and spectral-resolved fluorescence spectra of C522 were measured by using up-conversion set-up (CDP, FOG100). The p-cyclodextrin, C42H70O35, and coumarin C522, C14H12F3NO2, used in these experiments were produced by Cyclolab and Radiant Dyes Chemie, respectively. All experiments were performed at room temperature and used water was twice deionised. 

Miller, K. J. and Lytle, F. E., Capillary zone electrophoresis with time-resolved fluorescence detection using a diode-pumped solid-state laser, J. Chromatogr., 648, 245, 1993. 

Assembly station of a diode-pumped solid-state laser including a machine vision robot equipped with a high-resolution camera (Schmitt and Pavim 2009)... 

K. Ueda, N. Uehara Laser diode pumped solid state lasers for gravitational wave antenna. Proc. SPIE 1837, 337 (1992)... 

G.T. Forrest Diode-pumped solid state lasers have become a mainstream technology. Laser Focus 23, 62 (1987)... 

In addition to the relaxation peak, there are peaks in the RIN spectrum at frequencies that correspond to the difference in frequency between the longitudinal modes. The typical mode spacing of early diode-pumped solid-state lasers was about 4 GHz. This puts the first intermodal RIN peak outside the... 

G.P.A. Malcolm, A.I. Ferguson Diode-pumped solid-state lasers. Con-temp. Phys. 32, 305 (1991)... 

Introduction to Laser Diode-Pumped Solid State Lasers, Richard Scheps, Vol. TT53... 

Ostendorf A., Korber, K., Nether, T, and Temme, T. (2000) Material processing applications for diode pumped solid state lasers. Lambda Physics Highlights, 57, 1. 

Figure 5.28 Upper experimental setup [40], Lenses LI and L2 are used to expand a plane wave, and D is a diaphragm. Lenses L3 and L4 are the transformation lenses, A is an analyzer, and DPSS a diode-pumped solid-state laser. The DDLC sample is placed in the transform plane. Sc is the command surface that changes the orientation of the photosensitive dye absorbed on it Sg is the reference surface with rubbed and fixed LC alignment. Lower the object (a grating mask with 25 mm spacing) is a periodic step function that produces numerous diffracted orders after Fourier transformation LI, lens. Reproduced from T.-H. Lin and A. Fuh, Polarization controllable spatial filter based on azo-dye-doped liquid-crystal film. Optics Letters 30, 1390 (2005), Optical Society of America...

A bistable photoswitchable reflective liquid crystal display (PRLCD) based on azo-dye doped liquid crystal (DDLC), which can be written, erased, and rewritten by changing the polarization of a writing laser beam has been demonstrated [2], The mechanism is primarily due to thephotoinduced adsorption of azo-dyes doped in the LC cell. Linearly polarized diode-pumped solid-state laser light with X = 532 nm and an intensity of 150 mW/cm was employed as a writing beam to switch the DDLC sample from a homogeneous texture to a 45° twisted nematic (TN) one (Figure 6.2). 

---