Dimethyl sulfoxide reactivity

I itro-DisplacementPolymerization. The facile nucleophilic displacement of a nitro group on a phthalimide by an oxyanion has been used to prepare polyetherimides by heating bisphenoxides with bisnitrophthalimides (91). For example with 4,4 -dinitro monomers, a polymer with the Ultem backbone is prepared as follows (92). Because of the high reactivity of the nitro phthalimides, the polymerkation can be carried out at temperatures below 75°C. Relative reactivities are nitro compounds over halogens, Ai-aryl imides over A/-alkyl imides, and 3-substituents over 4-substituents. Solvents are usually dipolar aprotic Hquids such as dimethyl sulfoxide, and sometimes an aromatic Hquid is used, in addition. 

The use of dimethyl sulfoxide-acetic anhydride as a reagent for the oxidation of unhindered steroidal alcohols does not appear to be as promising due to extensive formation of by-products. However, the reagent is sufficiently reactive to oxidize the hindered 11 j -hydroxyl group to the 11-ketone in moderate yield. The use of sulfur trioxide-pyridine complex in dimethyl sulfoxide has also been reported. The results parallel those using DCC-DMSO but reaction times are much shorter and the work-up is more facile since the separation of dicyclohexylurea is not necessary. Allylic alcohols can be oxidized by this procedure without significant side reactions. 

In order to enable the dimethyl sulfoxide 3 to oxidize the alcohol substrate effectively, it has to be converted into an reactive agent. This is carried out by treatment with oxalyl chloride 4, hence leading to sulfonium ions 5 or 6 as the active species ... 

Powdered sodium amide reacts with dimethyl sulfoxide to generate the sodium salt under the same conditions, with the evolution of ammonia, and is comparable to sodium hydride in its reactivity. 

In a recently published paper6, on the investigation of AN copolymerization with the quartemary salt of l,2-dimethyl-5-vinylpyridinium sulfate (DMVPS) in dimethyl sulfoxide (DMSO) with 2,2 -azoisobutyronitrile as initiator, and in aqueous medium in the presence of the potassium persulfate/sodium metabisulfite oxidation-reduction system at 60 °C, the authors found the reactivity of the monomers, especially that of MVPS (methylvinylpyridin sulfate) to depend significantly on the polarity of the medium. 

The rate of alkylation of enolate ions is strongly dependent on the solvent in which the reaction is carried out.41 The relative rates of reaction of the sodium enolate of diethyl n-butylmalonate with n-butyl bromide are shown in Table 1.3. Dimethyl sulfoxide (DMSO) and iV,Ai-dimethylformamide (DMF) are particularly effective in enhancing the reactivity of enolate ions. Both of these are polar aprotic solvents. Other... 

Alkyltriphenylphosphonium halides are only weakly acidic, and a strong base must be used for deprotonation. Possibilities include organolithium reagents, the anion of dimethyl sulfoxide, and amide ion or substituted amide anions, such as LDA or NaHMDS. The ylides are not normally isolated, so the reaction is carried out either with the carbonyl compound present or with it added immediately after ylide formation. Ylides with nonpolar substituents, e.g., R = H, alkyl, aryl, are quite reactive toward both ketones and aldehydes. Ylides having an a-EWG substituent, such as alkoxycarbonyl or acyl, are less reactive and are called stabilized ylides. 

Some efforts have been taken to obtain the electrochemical response of Hb at solid electrode surfaces. Fan s electrochemical researches revealed that the electron-transfer reactivity of Hb could be greatly enhanced, simply by treating it with an organic solvent, dimethyl sulfoxide (DMSO) [115], Hb can also achieve its direct electron transfer in /V,/V-dimcthy I form am idc (DMF) film, as Xu [116] reported. These, therefore, suggested that there are many different factors that regulate electron-transfer reactivity of proteins. It also pointed out the complicated and precise regulation mechanisms of proteins in vivo. 

Bajoras and Makuska investigated the effect of hydrogen bonding complexes on the reactivities of (meth)acrylic and isotonic acids in a binary mixture of dimethyl sulfoxide and water using IR spectroscopy (Bajoras and Makuska, 1986). They demonstrated that by altering the solvent composition it was possible to carry out copolymerization in the azeotropic which resulted in the production of homogeneous copolymers of definite compositions at high conversions. Furthermore, it was shown that water solvent fraction determines the rate of copolymerization and the reactivity ratios of the comonomers. This in turn determines the copolymer composition. 

The discussion continues regarding the role of silanone and cyclodisiloxanes as reactive intermediates in the formation of Si-O-Si bond.25 In studies of the reaction of dimethyldichlorosilane, phenylmethyldichlorosilane, or diphenyldichlorosilane with dimethyl sulfoxide in the presence of 2,2,5,5-tetramethyl-l-oxa-2,5-disilacyclopentane, Weber and co-workers obtained products of the insertion of diorganosiloxy unit into the cyclic siloxane, accompanied... 

The proportion of C-alkylation increases in the order OTs < Br < I, a sequence which is often associated with the balance of hardness between nucleophile and nucleofuge (Smith and Hanson, 1971). The work of Kurts et al. (1974) indicates that the overall reaction rate of the crown ether-assisted alkylation increases in the order Na+ < K+ < Rb+ < Cs+, which, according to these authors, reflects the increasing distance between cation and anion in the ion pairs. The high reactivity of the tetraphenylarsenate also fits in with this picture. The decrease of the kc/k0 ratio is only small in good cation-solvating solvents such as dimethyl sulfoxide (DMSO). Alkylation of the sodium derivative of [103] with ethyl iodide in DMSO gave kc/kQ = 15.7 addition of... 

Oxathietanes and oxathietes have been cited in the literature only as reactive transient intermediates and not as isolated relatively stable products. The cycloaddition of dimethyl sulfoxide to the acetylene derivative 277 yielded via the 1,2-oxathiete 278 the acyclic structure 279 ° (Eq. 76). 

TITTe have reported that the triphenylmethide ion in dimethyl sulfoxide (DMSO) solution reacts with oxygen at a rate approaching the diffusion-controlled limit (k > 109 liters/mole sec.) (16). The triphenylmethide ion is actually more reactive toward molecular oxygen than the triphenylmethyl radical. Because of the reactivity of the triphenylmethyl anion toward molecular oxygen, it is possible to measure the rate of ionization of triphenylmethane in basic solution by the rate of oxygenation. 

Figure 8.24a, for example, shows the FTIR spectrum before the photolysis of mixtures of DMS in air with h2o2 as the OH source and the residual spectrum after 5 min of photolysis (Barnes et al., 1996). The reactants, as well as the product S02 have been subtracted out in Fig. 8.24b. Dimethyl sulfoxide (DMSO) as well as dimethyl sulfone, CH3S02CH3 (DMS02), and small amounts of COS are observed as products. DMSO is so reactive that it is rapidly converted into DMS02 in this system and hence both are observed in Fig. 8.24b. However, Barnes and co-workers calculate that the DMSO yield corrected for secondary oxidation is about the same as the fraction of the OH-DMS reaction that proceeds by addition under these conditions, i.e., that the major fate of the adduct is reaction (47). Turnipseed et al. (1996) measured the yield of H02 from reaction (47) to be 0.50 + 0.15 at both 234 and 258 K, suggesting that there are other reaction paths than (47) as well. The mechanism of formation of COS is not clear but may involve the oxidation of thioformaldehyde (H2C=S). The implications for the global budget of COS are discussed by Barnes et al. (1994b, 1996).

Our alternative approach has been to synthesize the solvento intermediate and then study its reactions in isolation. We thereby hope to show that its reactivity and steric course is inconsistent with the postulate stating that it is an intermediate in the substitution reactions. Complexes of the type cis- and trans-[Co en2 CH3OH q]+2 (7)f and cis-[Co en2 (CH3)2SO Cl]+2 32) have been prepared. We have shown in the first case that the lability of the coordinated methanol does not sufficiently explain the nonappearance of the solvento complex in the reactions of cis- and trans-[Co en2 Cb]"1" in methanol unless it is not an intermediate in the reaction. In dimethyl sulfoxide solution, cis- and trans-[Co en2 Cb] have been shown to isom-erize to an equilibrium mixture that also contains the solvento intermediate 32). 

---