Formulations evaluation after dilution

A series of DCE-based formulations containing Igepal CO-630 Special (N9) and dextran sulfate (DS) were evaluated for in vitro contraceptive testing. Also included in the screening tests were placebos, N9, two commercial spermicidal products (Conceptrol and KY Plus), vaginal moisturizer products (KY Jelly and Replens ), and saline. Test results are summarized in Table 6. The N9-containing products exhibited similar spermicidal activity, as illustrated by the minimum effective concentration (MEC). Samples without N9 did not have spermicidal activity. DCE placebo vehicle inhibits sperm penetration into the cervical mucus, illustrated by the very low MOET values after 1 10 and 1 160 dilutions. This activity has not been reported for anionic or nonionic polymer vehicles. There are no striking differences... 

The bicontinuous-microemulsion polymerization technique has also been used to develop novel proton exchange membranes (PEM) for fuel cell evaluation [97]. A series of hydrocarbon-based membranes were prepared based on the formulation shown in Fig. 5, with additional ionic vinyl monomers such as VB-SLi or bis-3-sulfopropyl-itaconic acid ester. After polymerization, the membranes were treated with dilute H2SO4 (0.5 M) to convert them to PEM membranes. The good performance of these PEM membranes in a single fuel cell is illustrated in Fig. 9. 

I 79 Methods of Evaluating Formulations after Dilution Latex mixture - volume / ... 

---