Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Diffusion frequency dependent

The frequency-dependent spectroscopic capabilities of SPFM are ideally suited for studies of ion solvation and mobility on surfaces. This is because the characteristic time of processes involving ionic motion in liquids ranges from seconds (or more) to fractions of a millisecond. Ions at the surface of materials are natural nucleation sites for adsorbed water. Solvation increases ionic mobility, and this is reflected in their response to the electric field around the tip of the SPFM. The schematic drawing in Figure 29 illustrates the situation in which positive ions accumulate under a negatively biased tip. If the polarity is reversed, the positive ions will diffuse away while negative ions will accumulate under the tip. Mass transport of ions takes place over distances of a few tip radii or a few times the tip-surface distance. [Pg.277]

Some experiments outlined the frequency dependence of phonon scattering on surfaces [74]. Thus, Swartz made the hypothesis that a similar phenomenon could take place at the interface between solids and proposed the diffuse mismatch model [72]. The latter model represents the theoretic limit in which all phonons are heavily scattered at the interface, whereas the basic assumption in the acoustic mismatch model is that no scattering phenomenon takes place at the interface of the two materials. In the reality, phonons may be scattered at the interface with a clear reduction of the contact resistance value as calculated by the acoustic model. [Pg.112]

Fig. 6.8 (a) Calculated frequency-dependent conductivity for a simple dynamic percolation model. Lower line represents the diffusion coefficient without renewal, upper that with renewal. (f ) Frequency-dependent conductivity for pure PEO (bold) and PEO-NaSCN at 22 °C. Only ions are able to diffuse long distances, corresponding to renewal diffusion. [Pg.142]

The voltammetric features of a reversible reaction are mainly controlled by the thickness parameter A = The dimensionless net peak current depends sigmoidally on log(A), within the interval —0.2 < log(A) <0.1 the dimensionless net peak current increases linearly with A. For log(A )< —0.5 the diSusion exhibits no effect to the response, and the behavior of the system is similar to the surface electrode reaction (Sect. 2.5.1), whereas for log(A) > 0.2, the thickness of the layer is larger than the diffusion layer and the reaction occurs under semi-infinite diffusion conditions. In Fig. 2.93 is shown the typical voltammetric response of a reversible reaction in a film having a thickness parameter A = 0.632, which corresponds to L = 2 pm, / = 100 Hz, and Z) = 1 x 10 cm s . Both the forward and backward components of the response are bell-shaped curves. On the contrary, for a reversible reaction imder semi-infinite diffusion condition, the current components have the common non-zero hmiting current (see Figs. 2.1 and 2.5). Furthermore, the peak potentials as well as the absolute values of peak currents of both the forward and backward components are virtually identical. The relationship between the real net peak current and the frequency depends on the thickness of the film. For Z, > 10 pm and D= x 10 cm s tlie real net peak current depends linearly on the square-root of the frequency, over the frequency interval from 10 to 1000 Hz, whereas for L <2 pm the dependence deviates from linearity. The peak current ratio of the forward and backward components is sensitive to the frequency. For instance, it varies from 1.19 to 1.45 over the frequency interval 10 < //Hz < 1000, which is valid for Z < 10 pm and Z) = 1 x 10 cm s It is important to emphasize that the frequency has no influence upon the peak potential of all components of the response and their values are virtually identical with the formal potential of the redox system. [Pg.133]

The dipolar component arises from diffusion of bound charge or molecular dipole moments. The frequency dependence of the polar component may be represented by the Cole-Davidson function ... [Pg.104]

As a new subject we have considered the effect of the frequency-dependence of the elastic moduli on dynamic light scattering. The resultant nonexponential decay of the time-correlation function seems to be observable ubiquitously if gels are sufficiently compliant. Furthermore, even if the frequency-dependent parts of the moduli are very small, the effect can be important near the spinodal point. The origin of the complex decay is ascribed to the dynamic coupling between the diffusion and the network stress relaxation [76], Further scattering experiments based on the general formula (6.34) should be very informative. [Pg.118]

In the previous section we have discussed the relation between the time- and frequency-dependent friction and viscosity in the normal liquid regime. The study in this section is motivated by the recent experimental (see Refs. 80-87) and computer simulation studies [13,14, 88] of diffusion of a tagged particle in the supercooled liquid where the tagged particle has nearly the same size as the solvent molecules. These studies often find that although the fric-... [Pg.140]

In order to complete the above analysis, one needs to solve the full non-Markovian Langevin equation (NMLE) with the frequency-dependent friction for highly viscous liquids to obtain the rate. This requires extensive numerical solution because now the barrier crossing dynamics and the diffusion cannot be treated separately. However, one may still write phenomenologically the rate as [172],... [Pg.191]

Note that the above study is performed for a simple system. There exists a large body of literature on the study of diffusion in complex quasi-two-dimensional systems—for example, a collodial suspension. In these systems the diffusion can have a finite value even at long time. Schofield, Marcus, and Rice [17] have recently carried out a mode coupling theory analysis of a quasi-two-dimensional colloids. In this work, equations for the dynamics of the memory functions were derived and solved self-consistently. An important aspect of this work is a detailed calculation of wavenumber- and frequency-dependent viscosity. It was found that the functional form of the dynamics of the suspension is determined principally by the binary collisions, although the mode coupling part has significant effect on the longtime diffusion. [Pg.203]

Calculational procedure of all the dynamic variables appearing in the above expressions—namely, the dynamic structure factor F(q,t) and its inertial part, Fo(q,t), and the self-dynamic structure factor Fs(q,t) and its inertial part, Fq (q, t) —is similar to that in three-dimensional systems, simply because the expressions for these quantities remains the same except for the terms that include the dimensionality. Cv(t) is calculated so that it is fully consistent with the frequency-dependent friction. In order to calculate either VACF or diffusion coefficient, we need the two-particle direct correlation function, c(x), and the radial distribution function, g(x). Here x denotes the separation between the centers of two LJ rods. In order to make the calculations robust, we have used the g(x) obtained from simulations. [Pg.206]

From this molecular theory, we see that the diffusion coefficient depends on the frequency of cooperative main-chain motions of the polymer, v, which cause chain separations equal to or greater than the penetrant diameter. Pace and Datyner were able to estimate v by adopting an Arrhenius rate expression in which the pre-exponential factor, A, is a function of both AE and T. The diffusion coefficient is given by,... [Pg.98]

This equation, also as equation (6.49) gives description of the frequency dependency of dynamic modulus at low frequencies (the terminal zone). Both in equation (6.49) and (9.35), the second terms present the contribution from the orientational relaxation branch, while the first ones present the contribution from the conformational relaxation due to the different mechanisms diffusive and reptational. [Pg.183]


See other pages where Diffusion frequency dependent is mentioned: [Pg.138]    [Pg.108]    [Pg.267]    [Pg.268]    [Pg.7]    [Pg.42]    [Pg.62]    [Pg.141]    [Pg.116]    [Pg.11]    [Pg.100]    [Pg.101]    [Pg.130]    [Pg.102]    [Pg.149]    [Pg.175]    [Pg.106]    [Pg.139]    [Pg.205]    [Pg.215]    [Pg.130]    [Pg.68]    [Pg.91]    [Pg.10]    [Pg.74]    [Pg.109]    [Pg.49]    [Pg.105]   
See also in sourсe #XX -- [ Pg.53 ]




SEARCH



Diffusion dependencies

Diffusivity dependence

Frequency Dependencies

Frequency dependence

© 2024 chempedia.info