Dibromobutanes

Dibromobutane and 1 5 dibromopentane are conveniently prepared from the readily available tetrahydrofuran (I) and tetrahydrop3uan (II) respectively ... 

Dibromobutane from 1 4 butanediol). In a 500 ml. threenecked flask fltted with a stirrer, reflux condenser and dropping funnel, place 154 g. (105 ml.) of 48 per cent, hydrobromic acid. Cool the flask in an ice bath. Add slowly, with stirring, 130 g. (71 ml.) of concentrated sulphuric acid. To the resulting ice-cold solution add 30 g. of redistilled 1 4-butanediol dropwise. Leave the reaction mixture to stand for 24 hours heat for 3 hours on a steam bath. The reaction mixture separates into two layers. Separate the lower layer, wash it successively with water, 10 per cent, sodium carbonate solution and water, and then dry with anhydrous magnesium sulphate. Distil and collect the 1 4-dibromo-butane at 83-84°/12 mm. The yield is 55 g. 

Dibromobutane (from 1 4-butanediol). Use 45 g. of redistilled 1 4-butanediol, 6-84 g. of purified red phosphorus and 80 g. (26 ml.) of bromine. Heat the glycol - phosphorus mixture to 100-150° and add the bromine slowly use the apparatus of Fig. Ill, 37, 1. Continue heating at 100-150° for 1 hour after all the bromine has been introduced. Allow to cool, dilute with water, add 100 ml. of ether, and remove the excess of red phosphorus by filtration. Separate the ethereal solution of the dibromide, wash it successively with 10 per cent, sodium thiosulphate solution and water, then dry over anhydrous potassium carbonate. Remove the ether on a water bath and distil the residue under diminished pressure. Collect the 1 4-dibromobutane at 83-84°/12 mm. the yield 3 73 g. 

When bromine adds to (Z) or (E) 2 butene the product 2 3 dibromobutane con tains two equivalently substituted chirality centers... 

Figures 7 13 and 7 14 depict the stereochemical relationships associated with anti addition of bromine to (E) and (Z) 2 butene respectively The trans alkene (E) 2 butene yields only meso 2 3 dibromobutane but the cis alkene (Z) 2 butene gives a racemic mixture of 2R 3R) and 2S 3S) 2 3 dibromobutane...

Thionyl chloride readily converts butanediol to 1,4-dichlorobutane [110-56-5] (130) and hydrogen bromide gives 1,4-dibromobutane [110-52-1]... 

Amino-3-phenylisothiazole cyclizes on reaction with 2-azido-3-ethylbenzothiazolylium borofluoride to give compound (110) (78HCA108). 4-Aminoisothiazole reacts with 1,4-dibromobutane to give 4-pyrrolidinylisothiazole (80MI41700). 

Further evidence for a bromine-bridged radical comes from radical substitution of optically active 2-bromobutane. Most of the 2,3-dibromobutane which is formed is racemic, indicating that the stereogenic center is involved in the reaction. A bridged intermediate that can react at either carbon can explain the racemization. When the 3-deuterated reagent is used, it can be shown that the hydrogen (or deuterium) that is abstracted is replaced by bromine with retention of stereochemistry These results are also consistent with a bridged bromine radical. 

Methylcyclopropane shows strikingly different reactivity toward chlorination and bromination under radical-chain conditions. With chlorine, cyclopropyl chloride (56%) is the major product, along with small amounts of 1,3-dichlorobutane (7%). Bromine gives a quantitative yield of 1,3-dibromobutane. Offer an explanation for the difference. 

With Freon 112 or 113 as a solvent, fluonnation of pnmary butyl halides with bromine trifluonde can give mixtures of primary and secondary fluorides When 1,4 dibromobutane is the substrate, 93% l-bromo-4-fluorobutane and 1% 1-bro-mo-3-fluorobutane is obtained, with 1,4 dichlorobutane, the product contains 65% l-chloro-3-fluorobutane and 35% 1-chloro 4 fluorobutane When 4-bromo- or 4-chlorobutyl trifluoroacetate is used, the ratio of 4-fluorobutyl tnfluoroacetate to 3 fluorobutyl trifluoroacetate is 1 4 The effect of solvent is measured in another set of experiments When the reaction of bromine trifluonde and l,3-dichloro-2-fluoropropane in either Freon 113 or hydrogen fluoride is allowed to proceed to 40% conversion, the product mixture has the composition shown m Table 1 [/O] When 1 chloro 2,3-dibromopropane is combined with one-third of a mole of bromine trifluonde, both 1 bromo 3 chloro-2-fluoropropane and l-chloro-2,3-di-fluoropropane are formed [//] (equation 10)... 

---