Reference device

For impulse withstand voltages across the contact gaps of an interrupting device, refer to lEC 60694 and lEC 60298, Wet or dew test is a weatherproof test (Section I4..5.I0) and is meant for outdoor assemblies. 

Note For details of temperature rise of various parts and materials of an HT switching device refer to lEC 60694. 

Relieving Capacity of Combinations of Safety Relief Valves and Rupture Disks or Non-Reclosure Devices (Reference ASME Code, Par. UG-127, UG-132). 

Vibration data are obtained by the following procedure (1) mounting a transducer onto the machinery at various locations, typically machine housing and bearing caps, and (2) using a portable data-gathering device, referred to as a vibration monitor or analyzer, to connect to the transducer to obtain vibration readings. 

In general, the sample volume is proportional to the size of the anvil and the press. Above 15 GPa large sample devices refer to millimetre and centimetre sized samples. This will require anvils of the order of decimetres to metres and presses from 200 to 50 000 tons. 

Note 2 Other devices refers to any of low-voltage transformers, low-voltage condensers, reactors, discharge coils, surge absorbers, meter transformers, switches, breakers and rec- ... 

If the sample is radioactively tagged, it can be quantitated with one of the radioscanning devices. Reference 21 provides more details of all the scanners, including photographs of them. 

This simple equipment will be used to construct the gradient forming device. Refer to Figure 17-1 for visualization of the apparatus. 

Single, double, triple refer to dispersive spectrometer type, PMT (photomultiplier tube), and CCD (charge-coupled device) refer to the detector. 

Transitional devices refer to devices that were regulated as drugs, prior to the enactment of the Medical Device Amendments Act of 1976. These devices were automatically placed into Class III, but may be transferred to Class I or II. 

Lab-on-Chip devices refer to devices that integrate one or several biochemical analysis functions on a chip of small size using semictMiductor manufacturing processes and are capable of handling extremely small volume of fluid. They usually have the size of oifly square millimeters to a few square centimeters and are able to handle fluid volumes down to picoUter levels. 

Here again, we place a bandpass filter of bandwidth B and center frequency after the square-law device. Referring to Fig. 7.11 and (7.93), we find... 

ISO 14971 (2000), Medical devices Application of risk management to medical devices (reference number ISO 14971 2000E). 

Remove the dosimeter charger (calibrating device) (refer to Figure S6.1). Most dosimeter chargers will have to be partially disassembled, the battery inserted following the manufacturer s recommendations, and then reassembled. 

This section allows a carrier to use an electronic system to captm e the driver s hours-of-service, rather than a paper log. Section 395.15 discusses the requirements for the systems presently in use, referred to as AOBRDs (Automatic On Board Recording Devices). Section 395.16, which was to have established the requirements for the next generation devices, referred to as EOBRs (Electronic On-Board Recording Devices), has been vacated along with the remedial directive rule due to a successful legal challenge. 

---