Density densification

The mats are moved along the line to the press loader. When the loader is filled and the press opens to remove the load of freshly pressed boards, the loader pushes the new boards into the unloader and deposits the load of mats on the press platens. The press closes as quickly as possible to the desired panel thickness. More pressure, as much as 4.8—6.9 MPa (700—1000 psi) is required to press high density dry-process hardboard, because the dry fiber exhibits much more resistance to compression and densification than wet fiber. Press temperatures are also higher, in the range of 220—246°C. No screens are used in the dry-process, but the moisture in the mats requires a breathe cycle during pressing to avoid blowing the boards apart at the end of the cycle. Because no screens are used, the products are called smooth-two-sides (S-2-S), in contrast to the wet-process boards, which have a screen pattern embossed into the back side and are known as smooth-one-side (S-l-S). 

Carbon—carbon composites for rocket nozzles or exit cones are usually made by weaving a 3D preform composed of radial, axial, and circumferential carbon or graphite fibers to near net shape, followed by densification to high densities. Because of the high relative volume cost of the process, looms have been designed for semiautomatic fabrication of parts, taking advantage of selective reinforcement placement for optimum thermal performance. 

Densification to what is practically hiU density is achievable for most materials. The resulting mechanical properties are equivalent to wrought parts in similar condition. In some materials, the properties of the HIP product are superior because of reduced anisotropy. 

In soHd-state sintering (29,68,78—81) densification occurs by soHd-state diffusion-controUed material support. Examples of two technologically important ceramics that density by soHd-state sintering are MgO-doped AI2O2 and Y202-stabili2ed Zr02-... 

Clarmer-Thickener Clarifiers can serve as thickeners, achieving additional densification in a deep sludge sump adjacent to the center that extends a shoi t distance radi ly and provides adequate retention time and pulp depth to compact the solids to a high density. Drive mechanisms on this type of clarifier usually must have higher torque capability than would be supplied on a standard clarifier. 

K) for very strong shocks and the densification may be as high as four times the normal density. 

The press closing time also influences the relative densifications of the surface and core layers of the wood mat during pressing (Figs. 9 and 10). Fig. 11 details the density profile of the particleboard panels prepared at short and longer press closing times [226]. The two cases differ in several aspects. (1) A short... 

The consequences of shape change are densification and loss of electrode porosity, increased current density caused by loss of zinc surface area, and finally earlier passivation. Two different forms of pasi-vation can stop the discharge of a zinc electrode before the active material is exhausted. "Spontaneous" passivation occurs... 

---