Cyclic voltammetry homogeneous kinetics

An alternative electrochemical method has recently been used to obtain the standard potentials of a series of 31 PhO /PhO- redox couples (13). This method uses conventional cyclic voltammetry, and it is based on the CV s obtained on alkaline solutions of the phenols. The observed CV s are completely irreversible and simply show a wave corresponding to the one-electron oxidation of PhO-. The irreversibility is due to the rapid homogeneous decay of the PhO radicals produced, such that no reverse wave can be detected. It is well known that PhO radicals decay with second-order kinetics and rate constants close to the diffusion-controlled limit. If the mechanism of the electrochemical oxidation of PhO- consists of diffusion-limited transfer of the electron from PhO- to the electrode and the second-order decay of the PhO radicals, the following equation describes the scan-rate dependence of the peak potential ... 

As with the other reaction schemes involving the coupling of electron transfer with a follow-up homogeneous reaction, the kinetics of electron transfer may interfere in the rate control of the overall process, similar to what was described earlier for the EC mechanism. Under these conditions a convenient way of obtaining the rate constant for the follow-up reaction with no interference from the electron transfer kinetics is to use double potential chronoamperometry in place of cyclic voltammetry. The variations of normalized anodic-to-cathodic current ratio with the dimensionless rate parameter are summarized in Figure 2.15 for all four electrodimerization mechanisms. 

The opposite situation (y/D/k -C <5), where the reaction layer is much thinner than the diffusion layer (as represented in the lower diagram of Figure 2.31) is more specific of electrochemistry, in the sense that the homogeneous follow-up reactions are more intimately connected with the electrode electron transfer step. The same pure kinetic conditions discussed earlier for cyclic voltammetry (Section 2.2.1) apply. In the case of a simple EC reaction scheme, as shown in the figure, the production of C in the bulk solution obeys exactly the same equations (2.32) to (2.34) as for B in the preceding case, as established in Section 6.2.8. 

Cyclic voltammetry and derivative cyclic voltammetry (DCV) can be used to study the homogeneous kinetics of the reactions of B generated... 

As discussed in Sects. 3.4 and 4.5, electrode processes coupled with homogeneous chemical reactions are very frequent and their study is of interest in many applied fields, such as organic electrosynthesis, ecotoxicity, biosciences, environmental studies, among others [15-17]. In this section, multipulse techniques (with a special focus on Cyclic Voltammetry) are applied to the study of the reaction kinetics and mechanisms of electrogenerated species. 

The two major classes of voltammetric technique 4 Evaluation of reaction mechanisms 6 General concepts of voltammetry 6 Electrodes roles and experimental considerations 8 The overall electrochemical cell experimental considerations 12 Presentation of voltammetric data 14 Faradaic and non-Faradaic currents 15 Electrode processes 17 Electron transfer 22 Homogeneous chemical kinetics 22 Electrochemical and chemical reversibility 25 Cyclic voltammetry 27 A basic description 27 Simple electron-transfer processes 29 Mechanistic examples 35... 

The origins of SECM homogeneous kinetic measurements can be found in the earliest applications of ultramicroelectrodes (UMEs) to profile concentration gradients at macroscopic (millimeter-sized) electrodes (1,2). The held has since developed considerably, such that short-lived intermediates in electrode reactions can now readily be identified by SECM under steady-state conditions, which would be difficult to characterize by alternative transient UME methods, such as fast scan cyclic voltammetry (8). 

---