Contents 9 Axial-Flow Turbines

Suspension of solids is maintained by upward movement of the liquid. In principle, use of a draft tube and an axial flow impeller will accomplish this flow pattern most readily. It turns out, however, that such arrangements are suitable only for low solids contents and moderate power levels. In order to be effective, the cross section of the draft tube must be appreciably smaller than that of the vessel, so that the solids concentration in the draft tube may become unpractically high. The usually practical arrangement for solids suspension employs a pitched blade turbine which gives both axial and radial flow. 

Such baffles convert the rotational motion of the fluid into mean flow currents in the vertical and radial directions which result in a turnover of the vessel contents. A similar result occurs when a nonpitched blade turbine has a stator ring mounted around it for the purpose of directing the discharge flow so that it is radial with no rotational component. Rea veil (Rl) describes a cruciform baffle, installed on the tank bottom under an axial propeller, which is also designed to induce vertical circulation instead of rotational flow. 

The solids are kept in suspension if the pumping capacity of the impeller causes strong enough circulation of the liquid. In most processes, complete suspension of the particles is not required. Often, so-called off-bottom suspension is sufficient, which means that all particles are moving above the bottom of the tank with some vertical velocity. Radial flow impellers are usually not very effective in suspending solid particles. Actually, about three times more power is required for a radial turbine to provide the same degree of uniformity compared to an axial turbine. This is because the radial turbines pick up particles from the bottom of the tank by the suction side of the impeller, which is only half of the total flow from the impeller. Due to the appearance of an upper and a lower circulation zone, the contents of the two zones are not sufficiently mixed. Axial impellers are therefore most frequently used for the suspension of solids in stirred tanks [65]. 

---