Cobalt amides

In order to explain certain anomalous behavior of cobaltous amide, Co(NHa)a, obtained as a result of the reaction ... 

N 13.72%, is expl. It was obtd by Bergstrom (Ref 2, p2632) by heating cobaltous amide, Co(NH2)2, in a vacuum above 120° dissolves in dil H2SOa with decompn. Its expl props were not investigated... 

Cobalt amide is placed in a vapor-pressure eudiometer (see Part 1, Fig. 85) and carefullydecomposed at 50-70°C in the absence... 

Adiponitrile undergoes the typical nitrile reactions, eg, hydrolysis to adipamide and adipic acid and alcoholysis to substituted amides and esters. The most important industrial reaction is the catalytic hydrogenation to hexamethylenediarnine. A variety of catalysts are used for this reduction including cobalt—nickel (46), cobalt manganese (47), cobalt boride (48), copper cobalt (49), and iron oxide (50), and Raney nickel (51). An extensive review on the hydrogenation of nitriles has been recendy pubUshed (10). 

Chevron Chemical Co. began commercial production of isophthahc acid in 1956. The sulfur-based oxidation of / -xylene in aqueous ammonia at about 320°C and 7,000—14,000 kPa produced the amide. This amide was then hydrolyzed with sulfuric acid to produce isophthahc acid at about 98% purity. Arco Chemical Co. began production in 1970 using air oxidation in acetic acid catalyzed by a cobalt salt and promoted by acetaldehyde at 100—150°C and 1400—2800 kPa (14—28 atm). The cmde isophthahc acid was dissolved and recrystallized to yield a product exceeding 99% purity. The Arco technology was not competitive and the plant was shut down in 1974. 

Introduction of the cobalt atom into the corrin ring is preceeded by conversion of hydrogenobyrinic acid to the diamide (34). The resultant cobalt(II) complex (35) is reduced to the cobalt(I) complex (36) prior to adenosylation to adenosylcobyrinic acid i7,i -diamide (37). Four of the six remaining carboxyhc acids are converted to primary amides (adenosylcobyric acid) (38) and the other amidated with (R)-l-amino-2-propanol to provide adenosylcobinamide (39). Completion of the nucleotide loop involves conversion to the monophosphate followed by reaction with guanosyl triphosphate to give diphosphate (40). Reaction with a-ribazole 5 -phosphate, derived biosyntheticaHy in several steps from riboflavin, and dephosphorylation completes the synthesis. 

Eatty amines are made by dehydration of amides to nitriles at 280—330°C, followed by hydrogenation of the nitrile over nickel or cobalt catalysts ... 

Most ring syntheses of this type are of modern origin. The cobalt or rhodium carbonyl catalyzed hydrocarboxylation of unsaturated alcohols, amines or amides provides access to tetrahydrofuranones, pyrrolidones or succinimides, although appreciable amounts of the corresponding six-membered heterocycle may also be formed (Scheme 55a) (73JOM(47)28l). Hydrocarboxylation of 4-pentyn-2-ol with nickel carbonyl yields 3-methylenetetrahy-drofuranone (Scheme 55b). Carbonylation of Schiff bases yields 2-arylphthalimidines (Scheme 55c). The hydroformylation of o-nitrostyrene, subsequent reduction of the nitro group and cyclization leads to the formation of skatole (Scheme 55d) (81CC82). 

A variety of catalysts including copper, nickel, cobalt, and the platinum metals group have been used successfully in carbonyl reduction. Palladium, an excellent catalyst for hydrogenation of aromatic carbonyls is relatively ineffective for aliphatic carbonyls this latter group has a low strength of adsorption on palladium relative to other metals (72,91). Nonetheless, palladium can be used very well with aliphatic carbonyls with sufficient patience, as illustrated by the difficult-to-reduce vinylogous amide I to 2 (9). 

Palladium complexes also catalyze the carbonylation of halides. Aryl (see 13-13), vinylic, benzylic, and allylic halides (especially iodides) can be converted to carboxylic esters with CO, an alcohol or alkoxide, and a palladium complex. Similar reactivity was reported with vinyl triflates. Use of an amine instead of the alcohol or alkoxide leads to an amide. Reaction with an amine, AJBN, CO, and a tetraalkyltin catalyst also leads to an amide. Similar reaction with an alcohol, under Xe irradiation, leads to the ester. Benzylic and allylic halides were converted to carboxylic acids electrocatalytically, with CO and a cobalt imine complex. Vinylic halides were similarly converted with CO and nickel cyanide, under phase-transfer conditions. ... 

Organomercury compounds undergo a similar reaction. Alkyl and aryl Grignard reagents can be converted to carboxylic esters with Fe(CO)5 instead of CO. Amides have been prepared by the treatment of trialkyl or triarylboranes with CO and an imine, in the presence of catalytic amounts of cobalt carbonyl ... 

It is of incidental interest that a little work has been done on dicobalt systems. Doyle and Sykes have made a study of the reduction of decammine-//-amidodi-cobalt(Ill), (NH3)5Co NH2-Co(NH3)5 , by V(II). Since the rate is independent of hydrogen-ion concentration the mechanism cannot involve an amide bridge and must be outer-sphere, as it is in the case of the reduction of Co(NH3)6 by V(1I) . Both the binuclear complex and Co(NH3)6 are inert to substitution but the former is capable of functioning as a two-equivalent oxidant. Thus the two likely mechanisms are... 

In 1989, Isayama and Mukaiyama reported a related Co-catalyzed coupling reaction that employs a,b-unsaturated nitriles, amides, and esters with PhSiLb as a hydrogen source [9]. Cobalt-bis(diketonato) complex, Co(II)(dpm)2 [dpm = bis(dipivaloylmethanato)] (5mol%), exhibited high catalytic activity at 20 °C in the coupling of excess acrylonitrile and ben-zaldehyde to provide b-hydroxy nitrile 4 in 93% yield (syn anti = 50 50) (Scheme 5). N,N-Dimethylacrylamide and methyl cinnamate both reacted... 

The variety and extent of research devoted to ligands carrying both O- and N-donors is simply immense. The type of cobalt(III) systems extant include amino acids, amino alcohols, amino ethers, amino phosphates, amino phenolates, as well as amide and imine analogs of these. These are met as simple chelates or more elaborate polydentates. Here, we highlight a strictly limited selection of examples to illustrate the type of systems reported no attempt at exhaustive review has been made. 

Another chemically more interesting spin labeled B12 derivative involves coordinate attachment of the nitroxyl function to the cobalt atom of a cobinamide. Fig. 22 shows a reaction in which an alkyl cobin-amide is mixed with 4-hydroxy-2,2,6,6-tetramethylpiperidine-N-oxyl. The nitroxide displaces water from the 6th coordination position very slowly and therefore this reaction is usually allowed to proceed for a few days with a large excess of nitroxide. From the properties of the coordinated nitroxide derivative discussed below, it is certain that the cobalt is coordinated by the N—O functional group. An analogous compound to that shown in Fig. 22 can be made with a similar nitroxide in which the 4-hydroxyl-group is missing. In this case the N—O-function is the only basic site on the molecule and therefore must be the position of attachment to the cobalt 119). 

---