Chip content

Direct cloning of ORFs has also been used for Hving cell arrays where the cDNAs, cloned in mammalian expression vectors, were spotted onto microscope slides. Mammalian cells growing onto these printed areas took up the cDNA and expressed the corresponding gene product (Ziauddin and Sabatini, 2001). 

---

In this chapter, we will present different types of biochips, including protein and antibody arrays, as well as carbohydrate, peptide and living cell arrays. We will discuss recent progress and current bottlenecks in high-throughput generation of chip content, surface chemistry, molecule attachment, detection methods, and also applications in the proteomic field and in drug discovery. 

The fat content of potato chips can be determined indirectly by weighing a sample before and after extracting the fat with supercritical CO2. The following data were obtained for the analysis of one sample of potato chips. ... 

Markow, P. G. Determining the Lead Content of Paint Chips, /. Chem. Educ. 1996, 73, 178-179. 

Chemical charge, Hquor composition, time of heatup, and time at temperature of reaction are all functions of the wood species or species mix being digested and the intended use of the pulp. A typical set of conditions for southern pine chips in the production of bleachable-grade pulp for fine papers is active alkaH, 18% sulfidity, 25% and Hquor-to-wood ratio, 4 1. Time of heatup is 90 min to 170°C time at temperature of reaction, 90 min at 170°C. Hardwoods require less vigorous conditions primarily because of the lower initial lignin content. 

In theory, whole-tree-energy plants have the potential to be more efficient than existing wood-fired generators, which are fueled by chipped wood with a relatively high moisture content (45%). The dried whole trees have a moisture content below 25%, and whole-tree plants potentially can be built to have a greater capacity and to employ high pressure, high temperature steam. 

In joining reinforced thermosetting pipe it is particularly important that the pipe be cut without chipping or cracking it. It is also important to sand, file, or grind any mold-release agent from the surfaces to be cemented. Joints are built up layer by layer of adhesive-saturated reinforcement by following the manufacturer s recommended procedure. Application of adhesive to the surfaces to be joined and assembly of these surfaces shall produce a continuous bond and provide an adhesive seal to protect the reinforcement from attack by the contents of the pipe. Unfilled or unbonded areas of the joint are considered defects and must be repaired. 

---