Change analysis diagram

The two dashed lines in the upper left hand corner of the Evans diagram represent the electrochemical potential vs electrochemical reaction rate (expressed as current density) for the oxidation and the reduction form of the hydrogen reaction. At point A the two are equal, ie, at equiUbrium, and the potential is therefore the equiUbrium potential, for the specific conditions involved. Note that the reaction kinetics are linear on these axes. The change in potential for each decade of log current density is referred to as the Tafel slope (12). Electrochemical reactions often exhibit this behavior and a common Tafel slope for the analysis of corrosion problems is 100 millivolts per decade of log current (1). A more detailed treatment of Tafel slopes can be found elsewhere (4,13,14). 

Fig. 7. Sensitivity analysis, (a) Changes in discount rate as indicated by a sensitivity diagram. At center axis the discount rate i = 10% and NRR = 10.74% ...

Each reactant and product appears in the Nemst equation raised to its stoichiometric power. Thermodynamic data for cell potentials have been compiled and graphed (3) as a function of pH. Such graphs are known as Pourbaix diagrams, and are valuable for the study of corrosion, electro deposition, and other phenomena in aqueous solutions.Erom the above thermodynamic analysis, the cell potential can be related to the Gibbs energy change... 

The cyclobutene-butadiene interconversion can serve as an example of the reasoning employed in construction of an orbital correlation diagram. For this reaction, the four n orbitals of butadiene are converted smoothly into the two n and two a orbitals of the ground state of cyclobutene. The analysis is done as shown in Fig. 11.3. The n orbitals of butadiene are ip2, 3, and ij/. For cyclobutene, the four orbitals are a, iz, a, and n. Each of the orbitals is classified with respect to the symmetiy elements that are maintained in the course of the transformation. The relevant symmetry features depend on the structure of the reacting system. The most common elements of symmetiy to be considered are planes of symmetiy and rotation axes. An orbital is classified as symmetric (5) if it is unchanged by reflection in a plane of symmetiy or by rotation about an axis of symmetiy. If the orbital changes sign (phase) at each lobe as a result of the symmetry operation, it is called antisymmetric (A). Proper MOs must be either symmetric or antisymmetric. If an orbital is not sufficiently symmetric to be either S or A, it must be adapted by eombination with other orbitals to meet this requirement. 

Thermogravimetric analysis (TGA) measures changes in weight of a sample being heated. A typical Thermogravimetric analysis (TGA) apparatus is shown in the following diagram ... 

This schematic diagram shows that the true composition of particles can be obtained only when the probe hole covers the particle entirely. When the probe hole covers both the particle and the matrix, the measured concentration is lower than the real one. Again, when an interface is not perpendicular to the cylinder of analysis, the apparent concentration change at the interface appears diffuse, even if the real concentration change is discrete. The standard deviation for concentration, a, is given by... 

---