Centrifuge speed control

The centrifugal pump directly driven by a variable-speed electric motor is the most commonly used hardware comoination for adjustable speed pumping. The motor is operated by an electronic-motor speed controller whose function is to generate the voltage or current waveform required by the motor to make the speed of the motor track the input command input signal from the process controller. 

The two principal elements of evaporator control are evaporation rate a.ndproduct concentration. Evaporation rate in single- and multiple-effect evaporators is usually achieved by steam-flow control. Conventional-control instrumentation is used (see Sec. 22), with the added precaution that pressure drop across meter and control valve, which reduces temperature difference available for heat transfer, not be excessive when maximum capacity is desired. Capacity control of thermocompression evaporators depends on the type of compressor positive-displacement compressors can utilize speed control or variations in operating pressure level. Centrifugal machines normally utihze adjustable inlet-guide vanes. Steam jets may have an adjustable spindle in the high-pressure orifice or be arranged as multiple jets that can individually be cut out of the system. 

Lubricating-oil governor and seal system cleaned Instrumentation and speed control checked Auxiliary heat recovery system Centrifugal Compressors... 

Probably the most widely used capacity control for the centrifugal compressor is speed control. The capacity curve when used with speed control covers a wide range. While electric variable speed motors offer a continuation to the speed control practice, there are some other alternatives available. Suction throttling has been widely used and offers a r sonable control range for a relatively low cost. 

Most induction ac motors are fixed-speed. However, a large number of motor applications would benefit if the motor speed could be adjusted to match process requirements. Motor speed controls are the devices which, when properly applied, can tap most of the potential energy savings in motor systems. Motor speed controls are particularly attractive in applications where there is variable fluid flow. In many centrifugal pump, fan, and compressor applications mechanical power grows roughly with the cube of the fluid flow. To move 80 percent of the nominal flow only half of the power is required. Centrifugal loads are therefore excellent candidates for motor speed control. Other loads that may benefit from the use of motor speed controls include conveyers, traction drives, winders, machine tools and robotics. 

The mixed acid (72), brought to the nitration house by means of a centrifugal pump, is fed into the nitrator via a metering pump. The flow of the two reacting liquids is maintained in the correct proportion by means of speed controller. 

A Throttling characteristics of centrifugal (c) -and positive- displacement (e, reciprocating d, rotary) pumps. B Control characteristics of positive displacement pumps a,b, Systems characteristics (b, after speed control) VFluid flow Ap, Differential pressure n, Speed h, Stroke length A, B, B, Operating points. 

Throttling of the suction of centrifugal and axial compressors wastes less power than throttling the discharge. Even less power is wasted by adjustment of built-in inlet guide vanes with a servomechanism which is a feedback control system in which the controlled variable is mechanical position. Speed control is a particularly effective control mode, applicable to large units that can utilize turbine or internal combustion drives control is by throttling of the supply of motive fluids, steam or fuel. 

Direct current motors are used for continuous operation at constant load when fine speed adjustment and high starting torque are needed. A wide range of speed control is possible. They have some process applications with centrifugal and plunger pumps, conveyors, hoists, etc. 

---