Carbonates, amino functionalization using

As shown in Figure 11.28, compared with pristine CNTs (A), the diameter of CNT-OH (B) is still maintained at 20-50 nm, except that the surface of the latter was much smoother, which was because of the fact that the hydroxylation reaction got rid of the amorphous carbon on the surface of pristine CNTs. However, after CNT-OH was amino-functionalized using APTES, not only did the diameter of CNTs increase to some degree, but also its... 

Acylation. Reaction conditions employed to acylate an aminophenol (using acetic anhydride in alkaU or pyridine, acetyl chloride and pyridine in toluene, or ketene in ethanol) usually lead to involvement of the amino function. If an excess of reagent is used, however, especially with 2-aminophenol, 0,A/-diacylated products are formed. Aminophenol carboxylates (0-acylated aminophenols) normally are prepared by the reduction of the corresponding nitrophenyl carboxylates, which is of particular importance with the 4-aminophenol derivatives. A migration of the acyl group from the O to the N position is known to occur for some 2- and 4-aminophenol acylated products. Whereas ethyl 4-aminophenyl carbonate is relatively stable in dilute acid, the 2-derivative has been shown to rearrange slowly to give ethyl 2-hydroxyphenyl carbamate [35580-89-3] (26). 

A second strategy is to attach a linker (also referred to as a handle or anchor) to the resin followed by assembly of the molecule. A linker is bifunctional spacer that serves to link the initial synthetic unit to the support in two discrete steps (Fig. 3). To attach a linker to a chloromethyl-PS resin, a phenol functionality such as handle 4 is used to form an ether bond (Fig. 4). To attach the same handle to an amino-functionalized support, acetoxy function 5 or a longer methylene spacer of the corresponding phenol is applied to form an amide bond. Both of these resins perform similarly and only differ in their initial starting resin [4], An alternative approach is to prepare a preformed handle in which the first building block is prederivatized to the linker and this moiety is attached to the resin. For peptide synthesis, this practice is common for the preparation of C-terminal peptide acids in order to reduce the amount of racemization of the a-carbon at the anchoring position [5],... 

Asymmetric induction during the reduction of 4-(48) was observed when a surface-modified carbon cathode was used.70 Optical yields were low but the effect of the chiral amino acid bound to the carbon surface was proved to be a true surface phenomenon. Induction of chirality by homogeneous rather than surface-bound agents has also been studied.71 All the isomeric acetylpyridines (48) were reduced in the presence of three different chiral alkaloids. Both carbinol products 2- and 4-(49) were shown to possess induced chirality, but the 3-carbinol (49) had none under any of the conditions tried. More rapid protonation of the intermediate was proposed to account for the lack of induced chirality. Optimization of optical yields was done.72 The pinacols (50) formed along with 49 were found to have no induced chirality. Optical yields have been as high as 50%.73 The role of electroabsorption was found to be important in the reduction of 2-(48).74 Product distributions were noted as a function of surfactant present in the electrolyte, carbinol 49 being favored... 

Four different aryldiazonium salts have been used to functionalize SWCNTs through electrochemical reduction. By XPS and Raman diffusion measurements, the growth of aryl chains on the sidewalls of the nanotubes was observed [178]. Electrically addressable biomolecular functionalization of SWCNT electrodes and vertically aligned carbon nanofiber electrodes with DNA was achieved by elec-trochemically addressing (reduction) of nitrophenyl substituted nanotubes and nanofibers. Subsequently, the resulting amino functions were covalently linked to DNA forming an array of DNA-CNT hybrid nanostructures (Scheme 1.28) [179],... 

One of the major products of amino acid metabolism is ammonia (NLI3), a molecule known to be highly toxic to higher organisms. In the liver, ammonia and carbon dioxide are used to produce a water-soluble form of nitrogen, urea, via the urea cycle. The liver passes this urea to the blood, which carries it to the kidneys to be filtered out and excreted in the urine. Since one function of the kidney is to collect and excrete urea, increases in the concentration of this compound in the blood are an indicator of poor kidney function. Since urea is formed in the liver, low blood urea nitrogen is often the consequence of impaired liver function due to disease or as the result of infection (hepatitis). 

The reductive amination of ketones with a steroid structure makes possible the formation of an amino or substituted amino function on various carbon atoms of the steroid skeleton. In this case, different oxo functions are simultaneously present in the same steroid skeleton and selective reductive amination can frequently occur, because of the differences in steric hindrance of the carbonyl groups. Thus, the reductive amination of steroid derivatives often takes place with high stereoselectivity. The catalyst commonly used for the reductive amination is palladium on charcoal35 38. 

---