Mixer bottom-entering

Bottom-entering mixer. (Chemical Engineering, August 2, 1976,... 

To complete the picture, there are also bottom-entering drives, shown in Fig. 7, which have the advantage of keeping the mixer off the top of all tanks and required superstructure, but have the disadvantage that if the sealing mechanism fails, the mixer is in a vulnerable location for damage and loss of product by leakage. 

Standard Geometry describes a vessel and mixer design based on a fluid depth equal to vessel diameter and a top-entering impeller having a diameter equal to 1/3 of vessel diameter and located with a clearance of 1/3 of vessel diameter above the bottom of the vessel. 

In the continuous hydrovinylation experiments, the ionic catalyst solution was placed in the reactor R, where it was in intimate contact with the continuous reaction phase entering from the bottom (no stirring was used in these experiments). The reaction phase was made up in the mixer from a pulsed flow of ethylene and a continuous flow of styrene and compressed CO2. 

Three types of impellers are commonly used in the low viscosity region, propellers, Fig. 1 turbines. Fig. 2 and axial flow turbines. Fig. 3. Impellers used on small portable mixers shown in Fig. 4, are oflen inclined at an angle as well as being off-center to give a good top-to-bottom flow pattern in the system. Fig. 5. Large top-entering drives usually use either the axial flow turbine or the radial flow flat blade turbine. For aerobic fermentation, the radial flow disc turbine is most common and is illustrated in Fig. 6. 

---