Boeing Company

PAA. Phosphoric acid anodization (PAA) was developed by the Boeing Company in the late 1960s and early 1970s to improve the performance of bonded... 

While the use of adhesive bonding is widespread among all aerospace firms, the author is most familiar with history and practice at The Boeing Company and will of necessity draw primarily on that resource. Adhesive bonding use at other firms will be included as much as possible. 

Fig. 4. B-52 landing gcai" door damage from sonic fatigue. Reproduced by permission of the Boeing Company.

Fig. 19. TTU of Sandwich A.sscmbly. Reproduced by Permission of The Boeing Company.

Fig. 26. Bonded fuselage doubler pattern. Reproduced by permis.sioii of the Boeing Company.

Fig. 27. Bonded fuselage skin corrosion. Reproduced by pennission of the Boeing Company.

Fig. 32. Empennage leading edge. square-edge panel. Reproduced by peniiission of the Boeing Company.

Exxon Research Engineering Company, Annandale, NJ 08801 The Boeing Company, Seattle, WA 98124... 

ERIC R. SCHWARTZ, The Boeing Company, Huntington Beach, California... 

The following figures were obtained from a brochure produced by the Boeing Company. From these figures determine whether it would have been a good deal for the American taxpayer to support the building of the Supersonic Transport (SST) in the winter of 1971. What other factors should be considered ... 

U3000 Uncooled Microbolometer Infrared Sensor , Data Sheet. The Boeing Company, Anaheim, CA, 1998. 

Smart systems involve sensing changing conditions and activating some sort of response, usually with an actuator. A project known as Active Aeroelastic Wing (AAW), conducted by the National Aeronautics and Space Administration (NASA), the U.S. Air Force Research Laboratory, and Boeing Company, studied wing elasticity in a modi-... 

---