Benzene ruthenium complex

The synthesis of the zero-valent, 1,3-cyclohexadiene benzene ruthenium complex 196a has been mentioned as a coproduct of the cyclohexadienyl complex 236a in the reduction of the benzene ruthenium dication 235 with lithium aluminum hydride. Reduction of 235 with sodium borohydride in THF, however, gives only the air-sensitive, yellow-green ruthenium(O) complex 196a (118). This reaction has been generalized to... 

Asymmetric epoxidation of olefins with ruthenium catalysts based either on chiral porphyrins or on pyridine-2,6-bisoxazoline (pybox) ligands has been reported (Scheme 6.21). Berkessel et al. reported that catalysts 27 and 28 were efficient catalysts for the enantioselective epoxidation of aryl-substituted olefins (Table 6.10) [139]. Enantioselectivities of up to 83% were obtained in the epoxidation of 1,2-dihydronaphthalene with catalyst 28 and 2,6-DCPNO. Simple olefins such as oct-l-ene reacted poorly and gave epoxides with low enantioselectivity. The use of pybox ligands in ruthenium-catalyzed asymmetric epoxidations was first reported by Nishiyama et al., who used catalyst 30 in combination with iodosyl benzene, bisacetoxyiodo benzene [PhI(OAc)2], or TBHP for the oxidation of trons-stilbene [140], In their best result, with PhI(OAc)2 as oxidant, they obtained trons-stilbene oxide in 80% yield and with 63% ee. More recently, Beller and coworkers have reexamined this catalytic system, finding that asymmetric epoxidations could be perfonned with ruthenium catalysts 29 and 30 and 30% aqueous hydrogen peroxide (Table 6.11) [141]. Development of the pybox ligand provided ruthenium complex 31, which turned out to be the most efficient catalyst for asymmetric... 

The hydroarylation of olefins is also achieved by using a ruthenium catalyst, TpRu(CO)(NCMe)(Ph) (Tp = hydridotris(pyrazolyl)borate) (Equation (34)).39 The reaction of benzene with ethene is catalyzed by the ruthenium complex to give ethylbenzene (TN = 51, TOF = 3.5 x 10 3mol 1 s-1 at 90 °G for 4h). The ruthenium-catalyzed reaction of benzene with propene gives the hydroarylation products with a 1.6 1.0 ratio of -propyl to isopropylbenzene, with 14 catalytic turnovers after 19 h. 

The ruthenium complex dimer (3.06 mg, 0.25 mol%) and the chiral ligand (5.08 mg, 2 mol%) were then weighed into the round-bottomed flask and any moisture was azcotropically removed via evaporation of benzene (5x5 mL) at reduced pressure. 

CsHuN, Ethanamine, A-ethyl-A-methyl-tungsten complex, 26 40, 42 C6HF5, Benzene, pentafluoro-gold complexes, 26 86-90 C H4I2, Benzene, 1,2-diido-iridium complex, 26 125 CJT, Phenyl platinum complex, 26 136 C,H,N, Pyridine osmium complex, 26 291 OHtS, Benzenethiol osmium complex, 26 304 QH7P, Phosphine, phenyl-cobalt-iron complex, 26 353 QH 1-Butyne, 3,3-dimethyl-mercury-molybdenum-ruthenium complex, 26 329-335 C6H 4P, Phosphine, triethyl-platinum complex, 26 126 platinum complexes, 26 135-140 CsHisPO, Triethyl phosphite iron complex, 26 61... 

CkH.jP, Phosphine, dimethylphenyl-ruthenium complex 26 273 C HU, Cyclooctene platinum complex, 26 139 C,H,N, Benzene, 2-isocyano-1,3-dimethyl-iron complexes, 26 53, 57 C H N, Benzenemethanamine, N,N,2-trimethyl-... 

The water-soluble Ru(II) complex [Ru(i76-C6H6)(CH3CN)3](BF4)2 catalyzed the biphasic hydrogenation of alkenes and ketones with retention of the catalyst in the aqueous phase (87). However, the ruthenium complex moved to the organic phase when benzaldehyde was hydrogenated. In a benzene-D20 system, H-D exchange was observed between H2 and D20. Both monohydridic pathway and a dihydridic pathway are possible for hydrogen activation, and these two different catalytic cycles influence the yield and product distribution. 

A tetrakis(trimethylphosphine)ruthenium complex of benzyne has been prepared6 26 by a reaction similar to that used for the Group 4 and 5 metals thermally induced /3-hydride elimination of methane or benzene from 1 or 2, respectively [Eq. (3)]. A careful study of the kinetics of the elimination of methane from 1 revealed that dissociation of trimethylphosphine pre-... 

The bisacetato ruthenium complex 28, on heating in 2-propanol, leads to the bridged hydrido dinuclear complexes 73 and 74. The bistrifluoroacetato complex 28 also leads to complex 73. The Tj2-acetato complex 39 was transformed in hot 2-propanol to another bridged hydrido derivative (75, arene = durene, mesitylene, p-cymene, hexamethylbenzene 60-70%). The introduction of alkyl substituents on the benzene ring is reflected by a shift of the p FI resonance toward high field (14,53). 

Photolysis of complex 125 (arene = benzene) in acetonitrile gives a quantitative yield of cyclopentadienyl tris(acetonitrile) ruthenium complex... 

Tj -Cyclohexadienyl ruthenium complexes have been obtained either by addition of nucleophiles to the arene ring of arene ruthenium(II) complexes or by protonation of ruthenium(O) complexes. The first complex prepared, the benzene cyclohexadienyl ruthenium cation 236a, has been obtained together with the zero-valent arene cyclohexadiene ruthenium(O) complex 196a, by reaction of 235a with lithium aluminum hydride (118) [Eq. (27)]. 

Kinetic studies have shown that electrophilicity in the iron triad is strongly metal dependent with Fe Ru, Os, and the nucleophilic reactivity order is PPh3 > P(0-tBu)3. Adducts 237 (PR3 = phosphites) react with water to give the cyclohexadienyl phosphonate complexes 239. Complex 235 is a effective catalyst for the conversion of phosphites to HP(0)(0R)2 (99,146,147) [Eq. (29)]. In a similar fashion, benzene ruthenium dications... 

Protonation of 322 with tetrafluoroboric acid in diethyl ether gives the cyclohexadienyl derivative 325 in 70% yield. Treatment of 325 with lithium aluminum hydride yields the biscyclohexadienyl osmium(II) complex 326. Treatment of 322 with PMe3 at 60°C gives the hydridophenyl osmium-(II) complex 181, rather than the expected arene bistrimethylphosphine osmium(O) compound, via intramolecular C—H bond activation of the benzene ligand (192,193) (Scheme 38). Compound 181 as well as the analogous ruthenium complex (92) have also been obtained directly by cocondensation of osmium or ruthenium atoms with benzene and tri-methylphosphine (62) [Eq. (44)]. 

Cocondensation of ruthenium atoms with 1,3-cyclohexadiene, and then CO, at -196°C affords the cyclohexadienyi cyclohexenyl carbonyl ruthenium complex 327, which can be transformed to the benzene cyclohexenyl carbonyl ruthenium cation 328 by hydride abstraction (194) [Eq. (45)]. 

Among other convenient nitrene precursors are chloramine-T (A-chloro-A-sodio-p-toluenesulfonamide), bromamine-T, sulfonamides in the presence of (diacetoxyiodo)benzene and various transition metal catalysts, and sulfonyl azides in the presence of ruthenium complexes . 

---