Bases losses from wall reactions

The decision to test is usually driven by unusual chemistry such as a new catalyst, reaction components, or reaction conditions. Immersion/mass loss method is primarily used in conjunction with microscopic examination. Process fluids from production or pilot runs are primarily used to best simulate potential corrosion. The test methods are custom designed based, in part, on cost and the ability to obtain sufficient quantities of test fluids, and handle the process conditions. Process conditions are tested outside the process control limits (e.g., temperatures, pH) to better accentuate the corrosion potential. These extremes have to be tempered by the stability of the products in the stream. For wall thicknesses greater than 0.250 in. (6.35 mm), a uniform loss of less than 10 mil/year (0.26 mm/year) is considered structurally acceptable. Signiflcandy lower levels of uniform loss are of concern for product or process contamination issues. Microscopic examination is used to determine potential localized corrosion concerns, such as pitting or stress cracking. Indications of pitting or stress corrosion in stamped areas of the coupon are of particular concern. U-bend tests are rarely used because of insufflcient test fluid quantities and availability. 

---