Balanced bellows safety relief valve

Balanced Bellows Safety Relief Valve - A balanced safety relief valve incorporates means for minimizing the effect of back pressure on the performance characteristics opening pressure, closing pressure, lift and relieving capacity. This is usually achieved by the installation of a bellows. 

Spring Pressure - The spring pressure is equal to the set pressure minus the superimposed back pressure for a conventional PR valve. For a balanced bellows safety relief valve, the spring pressure equals the set pressure. 

Figure 4. Typical balanced bellows safety relief valve.

Figure 6. Forces acting on discs of conventional and balanced bellows safety relief valves.

VARIABLE OR CONSTANT BACKPRESSURE SIZING FACTOR. K,. FOR BALANCED BELLOWS SAFETY RELIEF VALVES (VAPORS AND GASES)... 

Figure 17. Variable or constant back pressure sizing factor, Kw for 25% overpressure on balanced bellows safety relief valves (liquids only). The curve represents conqiromise of the valves reconunended by a number of relief valve manufacturers. This curve may be used wiien the make of dw valve is not known. When the make is known, the manufacturer should be consulted for the correction factor.

The permitted distinct values for the maximum allowable pressure drop depend, among other things, on the exact design of the valve. It is common practice to limit the maximum permitted pressure drop for the inlet pipe to 10% of the set pressure. For the outlet vent line from a balanced bellows safety relief valve a 30% pressure drop with respect to the set pressure is regarded as permissible. The manufacturers of relief valves provide the exact limit values. Therefore the data given here should be looked upon as recommendations without any mandatory character. 

For balanced bellows pressure relief valves, the maximum superimposed baek pressure should be specified. (For balanced bellows valves discharging to a safety valve header which is at atmospheric pressure under non-flowing conditions, the maximum back pressure is zero.)... 

Balanced safety relief valves may be used in systems where built-up and/or superimposed backpressure is high or variable. In general, the capacity of a balanced valve is not significantly affected by backpressures below 30 percent of the set pressure. Most manufacturers recommend keeping the backpressure on balanced valves below 45 to 50 percent of the set pressure. Consult API-526 and valve manufacturers for the maximum outlet pressure limit for bellows-type SRVs. 

Conventional balanced bellows and pilot operated safety relief valves... 

Comment These valves are typically equipped with a bellows which balances or eliminates the effect of variable or bnilt-up backpressnre that may exist in the system into which the safety relief valve discharges (Fig. 5.192). 

Other types of pressure-relief valves do not depend upon the back pressure for their performances. However, to ensure that the safety valves work at their maximum capacity, back pressure is limited to 50 percent of the relief valve set pressure. In the balanced bellows type valve, the spring does not act directly on the disk. Instead, it serves on a bellows first, which in turn acts on the disk. In case of the piston type, it works on the same principle as the bellows type, except that the bellows is replaced by a piston (see Figure 17B). The cross-sectional area of both the piston and the bellows is the same as the inlet nozzle of the valve and the effect of the back pressure on the top and the bottom of the disk creates equal balancing forces. That is, P,A is always equal to F, as shown in Figure 17B. 

---