Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Average -labelling

In the first case the 1 labeling Is known as the 1-Initial labeling and In the second as the 1-average labeling. In the Integral we have also a colllnear-type y dependent (and also B-and l-dependent) S matrix element. [Pg.461]

Fig. 10 Control chart for subgroup average label claim for samples taken throughout compressing of three batches. Twenty subgroups of size 5 were taken systematically from each batch and plotted in the order of production. Fig. 10 Control chart for subgroup average label claim for samples taken throughout compressing of three batches. Twenty subgroups of size 5 were taken systematically from each batch and plotted in the order of production.
Product Took alikes can be easy to produce using conventional printing processes. The average label and carton used in pharmaceuticals are quite easy to reproduce well enough to fool both the pharmacist and the patient, even though they may not mislead the expert. [Pg.135]

The end result of Eq. (13)-(22) is the conversion of five molecules of glyceraldehyde-3-phosphate to three molecules of ribulose-5-phosphate (see Fig. 6). Two of these molecules formed by Eq. (21) and (22) are labeled in carbon atom position 3, while the third one, from Eq. (19) and (20), is labeled in positions 1, 2, and 3. The resultant average labeling of ribulose phosphate is heavy in position 3 and lighter in positions 1 and 2. When the ribulose molecules, labeled after a few seconds photosynthesis with C 02, were degraded (Bassham et al., 1954), this pattern of... [Pg.40]

Qualitative and quantitative studies on the rate of incorporation of DNA precursors (e.g.,[ H]thymidine) into mt DNA by biochemical and autoradiographic methods and comparison with the average labeling rate in the nnclei of the same cell type. [Pg.401]

M. Baer, H. R. Mayne, V. Khare, and D, J. Kouri, Integral and differential cross sections for the H2(vj[=l) + H reaction. A comparison between average labelled infinite-order sudden approximation and classical treatments, Chem. Phys. Lett. 72 ... [Pg.304]

Table 27 2 includes a column labeled pi which is the isoelectric point of the ammo acid The isoelectric point, also called the isoionic point, is the pH at which the ammo acid has no net charge It is the pH at which the concentration of the zwitterion is a maximum At a pH lower than pi the ammo acid is positively charged at a pH higher than pi the ammo acid is negatively charged For the ammo acids m Table 27 2 pi is the average of pA i and pK 2 and lies slightly to the acid side of neutrality... [Pg.1118]

The time-weighted, 8-h average limit for exposure to bromine pentafluoride is 0.1 ppm (67). Materials of constmction suitable for use with the bromine fluorides include nickel. Monel metal, or Teflon. For shipping, bromine trifluoride and pentafluoride are classified as oxidizers under DOT regulations. The trifluoride also requires a poison label. [Pg.293]

The ripple experiment works as follows In Fig. 6, HDH and DHD are depicted by open and filled circles where the filled circles represent the deuterium labeled portions of the molecule and the open circles are the normal (protonated) portions of the chains. Initially, the average concentration vs. depth of the labeled portions of the molecules is 0.5, as seen along the normal to the interface, unless chain-end segregation exists at / = 0. If the chains reptate, the chain ends diffuse across the interface before the chain centers. This will lead to a ripple or an excess of deuterium on the HDH side and a depletion on the DHD side of the interface as indicated in the concentration profile shown at the right in Fig. 6. However, when the molecules have diffused distances comparable to Rg, the ripple will vanish and a constant concentration profile at 0.5 will again be found. [Pg.364]

Example 21.5 The coldroom in Example 21.3 has 12 lighting fittings labelled 280 W. The four evaporators each have three fan motors of 660 W gross per fan and 18 kW defrost heaters which operate alternately for 15 min twice a day. The fork-lift truck is rated 80 A at 24 V and will be in the store 20 min each hour during the 8-h working day. Two packers will be present for 10 min each hour. Estimate the average and peak loads (see Table 21.2). [Pg.219]

Fig. 3.46 Dynamical pivfiles for graph sequences Gs (defined in section 3.3.2), representing averages over Ng sequence samples. The x-axis labels each g G Gs, dashed lines denote pure range-r topologies r with gi = range-1, 1-dira lattice and vertical bars give the mean absolute deviations of a particular rneasiire. Each system has size. N = 12, with Ng and rules TZ as follows (a) Ng = 50, K = OTIO, (b) Ng = 25, Ti= OT26, (c) Ng = 50, 7 = T16, (d) dg = 50, 7 = T4. Fig. 3.46 Dynamical pivfiles for graph sequences Gs (defined in section 3.3.2), representing averages over Ng sequence samples. The x-axis labels each g G Gs, dashed lines denote pure range-r topologies r with gi = range-1, 1-dira lattice and vertical bars give the mean absolute deviations of a particular rneasiire. Each system has size. N = 12, with Ng and rules TZ as follows (a) Ng = 50, K = OTIO, (b) Ng = 25, Ti= OT26, (c) Ng = 50, 7 = T16, (d) dg = 50, 7 = T4.

See other pages where Average -labelling is mentioned: [Pg.323]    [Pg.198]    [Pg.679]    [Pg.12]    [Pg.293]    [Pg.227]    [Pg.4268]    [Pg.202]    [Pg.323]    [Pg.198]    [Pg.679]    [Pg.12]    [Pg.293]    [Pg.227]    [Pg.4268]    [Pg.202]    [Pg.252]    [Pg.735]    [Pg.1496]    [Pg.324]    [Pg.460]    [Pg.396]    [Pg.506]    [Pg.324]    [Pg.92]    [Pg.32]    [Pg.239]    [Pg.210]    [Pg.360]    [Pg.121]    [Pg.224]    [Pg.121]    [Pg.8]    [Pg.9]    [Pg.289]    [Pg.630]    [Pg.631]    [Pg.51]    [Pg.362]    [Pg.153]    [Pg.37]    [Pg.371]    [Pg.382]    [Pg.382]    [Pg.595]    [Pg.628]    [Pg.177]   
See also in sourсe #XX -- [ Pg.718 , Pg.719 , Pg.722 , Pg.723 ]




SEARCH



© 2024 chempedia.info