Anionic ring-opening polymerization cyclosiloxane

Sormani PM, McGrath JE (1985) Kinetics and mechanisms of the anionic ring opening polymerization of cyclosiloxanes in the presence of bis(l,3-aminopropyl tetramethyl-disiloxane) In McGrath JE (ed) Ring opening polymerization kinetics mechanisms and synthesis. ACS Symposium Series No 286... 

Summary PDMS-6-PEO short-chain diblock copolymers were prepared via anionic ring-opening polymerization of cyclosiloxanes. Applying this method, various well-defined block copolymers with different compositions were synthesized and their phase behavior was investigated. The polymers predominantly showed lamellar phases in aqueous solutions. At small surfactant concentrations, vesicles were formed, as observed via cryogenic TEM. The aggregates of the diblock copolymers were used for the formation of lamellar thin films, applying the evaporation-induced self-assembly approach. 

Mechanism of Equilibration. The generally accepted mechanism for the base-catalyzed ring-opening polymerization of cyclosiloxanes involves attack of the basic catalyst at the silicon atom (15). It has been proposed, and generally accepted, that the active species is a partially dissociated siloxanolate anion (13). In the results presented in this chapter, significant differences in reaction rates were observed as the corresponding cation of the siloxanolate species was varied. The more rapid disappearance of D4 and aminopropyldisiloxane in the presence of these catalysts increased in the following order ... 

Summary Phosfdiazene bases represent a new class of highly active non-ionic catalysts that rapidly polymerize cyclosiloxanes with equilibrium attained in very short reaction times at very low catalyst levels. To date, phosphazene base catalysts have been considered an academic curiosity because of the complicated and hazardous synthetic protocol used to prepare them. A facile synthetic process has been developed, which yields ionic phosphazene bases in three steps with an overall yield of qrproximately 75%. This is achieved through nucleophilic substitution of ionic phosphonitrilic chloride oligomers with secondary amines, followed by anion exchange. These ionic phosphazenes were found to exhibit similar reactivity in the ring-opening polymerization of cyclosiloxanes to that of the non-ionic phosphazene base. 

Ring-opening polymerization of cyclosiloxanes can be carried out by either cationic or anionic initiators. 

Cyclosilazanes are found to be reluctant to polymerize by the ring-opening process, probably for thermodynamic reasons. On the other hand, six- and eight-membered silazoxane rings are able to undergo anionic polymerization under similar conditions to those which have been widely used for cyclosiloxane polymerization provided there is no more than two silazane units in the cyclic monomer. They can also copolymerize with cyclosiloxanes however, the chain length of the linear polymer formed is substantially decreased with increasing proportion of silazane units. 

The anionic polymerization of cyclosiloxanes was examined In benzene and toluene with lithium cryptates as counterions. Only one type of active species Is observed In the case of LI + [211] thus, the kinetics of the propagation and of the by-product cyclosiloxanes formation can be studied In detail for the first time. The reactivity of cryptated sllanolate Ion pairs toward the ring opening of D3 Is greatly enhanced compared to that of other systems. 

---