Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

8-Anilino- 1-naphthalenesulfonic acid fluorescence

In two-phase systems, however, where surfactant and water can partition between a fluid and a liquid phase, significant pressure effects occur. These effects were studied for AOT in ethane and propane by means of the absorption probe pyridine N-oxide and a fluorescence probe, ANS (8-anilino-l-naphthalenesulfonic acid) [20]. The UV absorbance of pyridine A-oxide is related to the interior polarity of reverse micelles, whereas the fluorescence behavior of ANS is an indicator of the freedom of motion of water molecules within reverse micelle water pools. In contrast to the blue-shift behavior of pyridine N-oxide, the emission maximum of ANS increases ( red shift ) as polarity and water motion around the molecule increase. At low pressures the interior polarity, degree of water motion, and absorbance intensity are all low for AOT reverse micelles in the fluid phase because only small amounts of surfactant and water are in solution. As pressure increases, polarity, intensity, and water motion all increase rapidly as large amounts of surfactant and water partition to the fluid phase. The data indicate that the surfactant partitions ahead of the water thus there is a constant increase in size and fluidity of the reverse micelle water pools up to the one-phase point. An example of such behavior is shown in Fig. 4 for AOT in propane with a total fVo of 40. The change in the ANS emission maximum suggests a continuous increase in water mobility, which is due to increasing fVo in the propane phase, up to the one-phase point at 200 bar. [Pg.285]

Siano and coworkers [14] report the use of 8-anilino-l-naphthalenesulfonic acid (ANS) as a probe of environment polarity in polyacrylamides containing 1 mole percent n-dodecylacrylamide (estimated from feed ratio) in 2 wt% NaCl. ANS, an amphoteric probe is selectively solubilized at the water-hydrophobe interface. The fluorescence emission maximum is shifted from 520 nm, in aqueous environments to approximately 462 nm in hydrophobic environments [18]. Studies of the polymer described above and a homopolymer of acrylamide were accomplished by varying polymer concentration up to 5000 ppm at constant ANS concentration. In Fig. 2.10 a, a plot of the emission wavelength maximum of ANS vs polymer concentration indicated an increasingly hydro-phobic environment with increasing copolymer concentration. Above approximately 1000 ppm, emission wavelength remained constant, indicating that ANS... [Pg.24]

Although the very existence of CMC of surfactant dissolved in nonpolar has been questioned, the UV absorption and fluorescence emission measurements of AOT-solubilized solubilizates, such as tert-butylphenol, pyrene, and hemi-Mg salt of 8-anilino-l-naphthalenesulfonic acid, in isooctane provided evidence for the existence of CMC at different values of R = [H20]/[A0T] (with R < 3) and CMC value increases with increase in R. The values of CMC, obtained at different temperatures, were used to calculate standard enthalpy of micellization (AH j°) from Equation 1.13 and standard entropy of micellization (AS j ) from Equation 1.14, and these respective values vary from 38.07 to 44.81 kJ mol and 184.60 to 202.60 JK moE with increase in temperature from 20 to 45°C. The positive AH j values arise mainly from the dismantling of hydrated ions in the quasi-lattice of AOT interior. [Pg.60]

FIA of anionics without a phase separation may be based on the quenching effect of surfactants on the fluorescence intensity of 8-anilino-l-naphthalenesulfonic acid coupled with bovine serum albumin (83). Another method of avoiding a phase separation is to use a surfactant-selective electrode. Since interference is a problem, the surfactant-selective electrode approach is best coupled with online concentration with a reversed-phase column. Such a system has been demonstrated for trace analysis of sodium dodecylsulfate (84). [Pg.528]

The total lasalocid-membrane binding reaction is a very sensitive fimction of the membrane polar head group composition Incorporation of dimyristoyl phosphati-dic acid (DMPA) or dimyristoyl phosphatidyl ethanolamine (DMPE) into pure DMPC vesicles reduces the total lasalocid fluorescence relative to that observed in pure DMPC vesicles. Fluorescence lifetime experiments indicate the decrease in fluorescence is not due to reduction of the quantum yield of the bound lasalocid but rather to a reduction in the degree of binding. The sensitivity of total ionophore binding to polar head group composition is similar to that observed for the fluorescent spin probe l-anilino-8-naphthalenesulfonate and indicates... [Pg.100]


See other pages where 8-Anilino- 1-naphthalenesulfonic acid fluorescence is mentioned: [Pg.151]    [Pg.102]    [Pg.255]    [Pg.40]    [Pg.225]    [Pg.425]    [Pg.426]    [Pg.122]    [Pg.105]    [Pg.502]   
See also in sourсe #XX -- [ Pg.426 ]




SEARCH



3- Anilino-5-

8-Anilino-1-naphthalenesulfonic acid

Anilino acids

Fluorescence 6,2- naphthalenesulfonates

Naphthalenesulfonic acid

© 2024 chempedia.info