Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Alkynes carbocupration

Normant, J.-F. Alkyne Carbocupration and Polyene Synthesis. In Organocopper Reagents A Practical Approach, Taylor, R. J. K., Ed. Oxford University Press Oxford, 1994 pp 237-256. [Pg.578]

The Conia-ene reaction is a thermal cyclization of an alkyl ketone with an alkyne to give the corresponding a-vinylated ketone.98 The catalytic version of this reaction has been reported to generalize the process to more functionalized substrates.99 The intramolecular carbocupration of alkyne 94 has been investigated under basic conditions in the presence of a catalytic amount of copper iodide (Scheme 28).100 The cyclic product 95 is obtained in high yield. [Pg.312]

Carbocupration of alkynes by zirconacyclopentane derivatives can be performed according to the same procedure. Thus, the zirconocyclopentane 135, obtained by treatment of Bu2ZrCp2 with 1,6-heptadiene, reacts at room temperature with phe-nylacetylene to afford the adduct 136 through a carbocupration-reductive elimination mechanism. Cross-coupling followed by intramolecular carbocupration takes place in the case of the reaction with 1-bromohexyne, producing 137 (Scheme 2.66) [143]. [Pg.73]

The carbocupration of alkynes occurs in a cis fashion to afford the synthetically useful cis alkenyl products. Recently, copper-mediated introduction of heteroatoms such as stannyl and silyl groups has become frequently used in place of introduction of carbon units as an efficient strategy to build important precursors in syn-... [Pg.309]

In a similar manner, alkynes can undergo sequential carbometallation reactions, previously illustrated in equation (32).136 It is possible to combine carbocupration of alkynes with the use of a Michael acceptor as electrophile when that electrophile is a vinylphosphonium salt, carbocupration can be coupled to Wittig alkenation to result in a stereospecific synthesis of dienes via a one-pot, four-component, four carbon-carbon bond-forming reaction sequence.302... [Pg.262]

CARBAMIC ACID, (2-METHYL-2-BUTENYL)-, METHYL ESTER, 65, 159 Carbamic add, methyl ester, 65,159 Carboalumination of alkynes. 66, 64 Carbocupration of alkynes, 66, 65... [Pg.269]

A Prelude Preparation of Haloalkenes and Alkenylboronic Acid Derivatives, Important Building Blocks for Palladium-Mediated C,C Couplings Carbocupration of Alkynes... [Pg.705]

Fig. 16.17. Mechanism of the carbocupration of acetylene (R = H) or terminal alkynes (R H) with a saturated Gilman cuprate. The unsaturated Gilman cuprate I is obtained via the cuprolithiation product E and the resulting carbolithiation product F in several steps—and stereoselectively. Iodolysis of I leads to the formation of the iodoalkenes J with complete retention of configuration. Note The last step but one in this figure does not only afford I, but again the initial Gilman cuprate A B, too. The latter reenters the reaction chain "at the top" so that in the end the entire saturated (and more reactive) initial cuprate is incorporated into the unsaturated (and less reactive) cuprate (I). - Caution The organometallic compounds depicted here contain two-electron, multi-center bonds. Other than in "normal" cases, i.e., those with two-electron, two-center bonds, the lines cannot be automatically equated with the number of electron pairs. This is why only three electron shift arrows can be used to illustrate the reaction process. The fourth red arrow—in boldface— is not an electron shift arrow, but only indicates the site where the lithium atom binds next. Fig. 16.17. Mechanism of the carbocupration of acetylene (R = H) or terminal alkynes (R H) with a saturated Gilman cuprate. The unsaturated Gilman cuprate I is obtained via the cuprolithiation product E and the resulting carbolithiation product F in several steps—and stereoselectively. Iodolysis of I leads to the formation of the iodoalkenes J with complete retention of configuration. Note The last step but one in this figure does not only afford I, but again the initial Gilman cuprate A B, too. The latter reenters the reaction chain "at the top" so that in the end the entire saturated (and more reactive) initial cuprate is incorporated into the unsaturated (and less reactive) cuprate (I). - Caution The organometallic compounds depicted here contain two-electron, multi-center bonds. Other than in "normal" cases, i.e., those with two-electron, two-center bonds, the lines cannot be automatically equated with the number of electron pairs. This is why only three electron shift arrows can be used to illustrate the reaction process. The fourth red arrow—in boldface— is not an electron shift arrow, but only indicates the site where the lithium atom binds next.
The basicity of Gilman cuprates is so low that they do not undergo acid/base reactions with acetylene or higher terminal alkynes. Instead, Gilman cuprates effect the car-bocupration of the C=C triple bond (Figures 13.12 and 13.13). This reaction formally resembles the hydroboration of a C=C triple bond ( see example in Figure 13.10). The regioselectivity also is the same hence, the metal is connected to the Cl center of a terminal alkyne. Finally, the reaction shows the same stereoselectivity as in the case of the hydroboration of a C=C triple bond carbocupration occurs as a cis addition. [Pg.528]

The carbocupration of alkynes, that is, the addition to a non-activated C-C triple bond, is another classical reaction of organocopper compounds. Due to the high regioselectivity and m-stereoselectivity usually observed in... [Pg.527]

Various functionalized alkynes can be submitted to carbocupration reactions, such as alkoxyalkynes,150 alkynyl carbamates,151 acetylenic orthoesters,152 and thioalkynes.153 The carbocupration of orthoesters, for example, 204, has been used to prepare a-substituted esters of the type 206 by acidic hydrolysis of the adduct 205 (Scheme 51).152 This allows the formation of regioisomers that are not accessible by copper-mediated addition to acetylenic esters. A stereoselective synthesis of trisubstituted alkenes has been described by Normant et al.lSd> starting from phenylthio-acetylene 207. Carbocupration with lithium di- -butylcuprate affords the intermediate 208 which, upon addition of /z-butyllithium, undergoes a 1,2-metalate rearrangement to the vinylcuprate 209. The latter can be trapped with various electrophiles, for example, ethyl propiolate, providing product 210 with complete regio- and stereocontrol. [Pg.528]


See other pages where Alkynes carbocupration is mentioned: [Pg.73]    [Pg.82]    [Pg.118]    [Pg.315]    [Pg.82]    [Pg.118]    [Pg.315]    [Pg.15]    [Pg.119]    [Pg.358]    [Pg.360]    [Pg.606]    [Pg.868]    [Pg.65]    [Pg.236]    [Pg.865]    [Pg.867]    [Pg.872]    [Pg.893]    [Pg.896]    [Pg.897]    [Pg.897]    [Pg.898]    [Pg.899]    [Pg.899]    [Pg.899]    [Pg.694]    [Pg.707]    [Pg.707]    [Pg.707]    [Pg.709]    [Pg.528]   
See also in sourсe #XX -- [ Pg.73 , Pg.145 ]

See also in sourсe #XX -- [ Pg.73 , Pg.145 ]

See also in sourсe #XX -- [ Pg.896 , Pg.897 , Pg.898 , Pg.899 , Pg.900 ]

See also in sourсe #XX -- [ Pg.539 ]

See also in sourсe #XX -- [ Pg.4 ]

See also in sourсe #XX -- [ Pg.370 , Pg.371 ]

See also in sourсe #XX -- [ Pg.4 ]




SEARCH



Carbocupration

Carbocupration of alkyne

© 2024 chempedia.info