Aliphatic hydrocarbons demand

Silver sulfate is used as a catalyst to oxidize long chain aliphatic hydrocarbons in the determination of chemical oxygen demand (COD). 

Styrene-Butadiene Copolymer Elastomers. SBR elastomers are employed in low-cost contact adhesives suitable for less-demanding applications—such as when exposure to elevated temperature is not likely, and when a bond of moderate strength is adequate. They can be dissolved in aliphatic hydrocarbon solvents and used to bond solvent-sensitive substrates like expanded polystyrene. 

Whatever the specific type, a valid question for all ordinary emulsions with or without surfactants is what is the maximum amount of the dispersed phase in the continuous phase when the former will still remain dispersed In other words, at what volume ratio does an inversion (i.e. OAV to W/O and the reverse) take place Emulsions for particle preparation are known to have been prepared where the volume ratio of the two phases can go up to near 1 1 [18]. In addition and contrast to this general idea about the relative contents of the two phases, one must also refer to the highly concentrated water-in-oil emulsions which can be prepared with a fluorinated surfactant and a fluorocarbon/hydrogenated surfactant (pronouncedly hydrophobic) and a hydrocarbon [19]. In these W/O emulsions, up to 98% w/w water is added, but inversion is never achieved. Highly concentrated W/O emulsions have also been described recently by Hakansson etal. [20] where the surfactant is of the alcohol ethoxylated type, the dispersed phase is aqueous in nature and the continuous phase, an aliphatic hydrocarbon. It has been indicated that such emulsions may contain more than 99% of the dispersed phase. These are, however, very special cases and do not demand further discussion here. Without going into specificities, let us look at the general factors that may influence inversion [3, 21, 22] ... 

HBCD is a brominated aliphatic cyclic hydrocarbon used as a flame retardant in thermal insulation building materials, upholstery textiles, and electronics. In 2001, the world market demand for HBCD was 16,700 tons, from which 9,500 tons was sold in the EU. These figures make HBCD the second highest volume BFR used in Europe [29], HBCD may be used as an alternative for PBDEs in some applications. To date, there are no restrictions on the production or use of HBCD. As a result of their widespread use and their physical and chemical properties, HBCD are now ubiquitous contaminants in the environment and humans [30, 31]. 

The onset of World War II caused major expansion and teehnology innovation in the petroleum and petroehemieal industries, with major inereases in demands for (1) branched aliphatic and aromatic hydrocarbons, (2) high-purity toluene, (3) butadiene, and (4) nylon. What uses produeed eaeh of these demands [Some hints The jet engine was important only after 1950, mbber plantations were loeated in Malaysia, and eotton becomes weak and mildews when wet.]... 

The air demand of pyrolysis gases produced at high temperatures comes from light gases like CO and Hj, which catch the oxygen very fast, but do not form radicals. The NO, reduction efficiency of a gas generated at 800 "C comes from the radicals, which are produced by cracking hydrocarbons (aliphatic or aromatic). The air demand... 

Trichloroethylene is used widely by industry as a metal degreaser. It is especially valuable because of its cleaning properties, low flammability, and lack of a measurable flash point. Trichloroethylene also is used as a chemical process intermediate in fluorochemical and polyvinyl chloride (PVC) production. It has been used worldwide for more than 70 years. It is a colorless, volatile liquid, and is an unsaturated aliphatic halogenated hydrocarbon. In the United States, it is produced by The Dow Chemical Company and PPG Industries, Inc. In 1998, U.S. demand was about 171 million pounds (77,700 metric tons) of which about 15 million pounds (6,800 metric tons) were imported. About 84 million pounds (38,000 metric tons) were exported. The use of trichloroethylene in 1999 can be broken down into the following categories ... 

---