Aliphatic amines acylation

Note. PRIMARY ALIPHATIC AMINES. The lower amines are gases or low-boiling liquids (b.ps. CHjNH, 7 CiHjNH, 17 CH,(CH2,>,NH 49 (CHg)jCHNHa, 34 ) but may be encountered in aqueous or alcoholic solution, or as their crystalline salts. They are best identified as their benzoyl, or toluene-/>-sulphonyl derivatives (c/. (C) above), and as their picrates when these are not too soluble. This applies also to benzylamine, CjHsCHjNH, b.p. 185 also to ethylenediamine, usually encountered as the hydrate, NHj (CHj)j NH2,HjO, b.p. 116 , for which a moderate excess of the reagent should be used to obtain the di-acyl derivative. (M.ps., pp. 55 55 )... 

Acylation. Aliphatic amine oxides react with acylating agents such as acetic anhydride and acetyl chloride to form either A[,A/-diaLkylamides and aldehyde (34), the Polonovski reaction, or an ester, depending upon the polarity of the solvent used (35,36). Along with a polar mechanism (37), a metal-complex-induced mechanism involving a free-radical intermediate has been proposed. 

These Br nsted-type plots often seem to be scatter diagrams until the points are collated into groups related by specific structural features. Thus, p-nitrophenyl acetate gives four separate, but parallel, lines for reactions with pyridines, anilines, imidazoles, and oxygen nucleophiles.Figure 7-4 shows such a plot for the reaction of trans-cmmm c anhydride with primary and secondary aliphatic amines to give substituted cinnamamides.All of the primary amines without substituents on the a carbon (R-CHi-NHi) fall on a line of slope 0.62 cyclopentylamine also lies on this line. If this line is characteristic of normal behavior, most of the deviations become qualitatively explicable. The line drawn through the secondary amines (slope 1.98) connects amines with the structure R-CHi-NH-CHi-R. The different steric requirements in the acylation reaction and in the model process... 

Note Color reactions occur even before application of spray solution II [6]. Tertiary aliphatic amines and phenols with blocked ortho and para positions and aromatic N-acylated amines, e.g. acetanilide, do not react [1],... 

Larger accelerations were observed, using the same principle, for the geometrically less demanding formation of an amide from a primary aliphatic amine and an acyl phosphate (14, Scheme 6). In this case the uridine bases carry an imidazole side-chain (13). After 16 rounds of increasing selection pressure the best catalytic species accelerated the reaction of Scheme 6 over 105-fold... 

Very high yields of IV-t-butyloxycarbonylamines are obtained when solutions of hydrochlorides of primary or secondary aliphatic amines in methanol or ethanol are treated with di-t-butyl dicarbonate and ultrasound is applied until carbon dioxide is no longer evolved, e.g. equation 109. PhCH(OH)CHMeNHMe is acylated only at the nitrogen atom under these conditions349. 

This process has many benefits in the context of green chemistry it involves two enzymatic steps, in a one-pot procedure, in water as solvent at ambient temperature. It has one shortcoming, however-penicillin acylase generally works well only with amines containing an aromatic moiety and poor enantioselectivities are often observed with simple aliphatic amines. Hence, for the easy-on/easy-off resolution of aliphatic amines a hybrid form was developed in which a hpase [Candida antarctica hpase B (CALB)] was used for the acylation step and peniciUin acylase for the deacylahon step [22]. The structure of the acyl donor was also optimized to combine a high enanhoselectivity in the first step with facile deacylation in the second step. It was found that pyridyl-3-acetic acid esters gave optimum results (see Scheme 6.8). 

This is a general method of preparing enamines from a secondary aliphatic amine and cyclohexanone or cyclopentanone. Acylation of such enamines is the first step in a general procedure for increasing the chain length of a carboxylic acid by 5 or 6 carbon atoms and of a dicarboxylic acid by 10 or 12 carbon atoms.6 Alkylation of enamines of cyclohexanones by alkyl halides 7 or electrophilic olefins,8 followed by hydrolysis, is a good route to a-monoalkyl cyclohexanones. 

Subsequently, the phthalylglutamic acid (Fig. 7.75), a dicarboxylic acid, was shown to be teratogenic in mice when given on days 7 to 9 of pregnancy. However, other work has indicated that the phthalimide ring is of importance in the teratogenicity. Other studies have indicated that thalidomide acylates aliphatic amines such as putrescine and spermidine, histones, RNA, and DNA and that it may also affect ribosomal integrity. 

The a-methoxylated derivatives are shown to be versatile synthons because of the reactivity of the methoxy group near the nitrogen atom, a-Methoxycarbamates, prepared by anodic oxidation, were used as key intermediates in the synthesis of a-amino acids,200 a new carbon-phosphorus bond-forming reaction,200 and in a new method of acylation of aliphatic amines at the -position.201 The application of this reaction to the synthesis of pyrrolidine, piperidine, and tropane alkaloids is also described.202... 

Tritylamines can serve as both linkers and protective groups for aliphatic amines because, unlike benzhydrylamines, they do not usually undergo acylation when treated with activated acid derivatives. Tritylation of aliphatic amines is readily accomplished by adding excess amine to a support-bound trityl chloride. Illustrative cleavage reactions are listed in Table 3.21. 

Aromatic and heteroaromatic amines can be linked to insoluble supports using strategies similar to those used for aliphatic amines. Because of the lower basicities of aromatic amines, however, their /V-bcnzyl derivatives will usually be more susceptible to acidolytic cleavage than aliphatic /V-bcnzylamincs. For the same reason, N-acyl derivatives of aromatic amines will generally be more sensitive towards nucleophiles than the corresponding derivatives of aliphatic amines. 

Less reactive than acyl halides, but still suitable for difficult couplings, are symmetric or mixed anhydrides (e.g. with pivalic or 2,6-dichlorobenzoic acid) and HOAt-derived active esters. HOBt esters smoothly acylate primary or secondary aliphatic amines, including amino acid esters or amides, without concomitant esterification of alcohols or phenols [34], HOBt esters are the most commonly used type of activated esters in automated solid-phase peptide synthesis. For reasons not yet fully understood, acylations with HOBt esters or halophenyl esters can be effectively catalyzed by HOBt and HOAt [3], and mixtures of BOP (in situ formation of HOBt esters) and HOBt are among the most efficient coupling agents for solid-phase peptide synthesis [2]. In acylations with activated amino acid derivatives, the addition of HOBt or HOAt also retards racemization [4,12,35]. 

Various approaches have been used to prepare pyrroles on insoluble supports (Figure 15.1). These include the condensation of a-halo ketones or nitroalkenes with enamines (Hantzsch pyrrole synthesis) and the decarboxylative condensation of N-acyl a-amino acids with alkynes (Table 15.3). The enamines required for the Hanztsch pyrrole synthesis are obtained by treating support-bound acetoacetamides with primary aliphatic amines. Unfortunately, 3-keto amides other than acetoacetamides are not readily accessible this imposes some limitations on the range of substituents that may be incorporated into the products. Pyrroles have also been prepared by the treatment of polystyrene-bound vinylsulfones with isonitriles such as Tosmic [28] and by the reaction of resin-bound sulfonic esters of a-hydroxy ketones with enamines [29]. 

Another class of problematic amines are a-amino nitriles, which are readily accessible from ketones, amines, and cyanide. Like a-amino acids, these amines are electronically deactivated and less basic and nucleophilic than purely aliphatic amines, and are therefore difficult to acylate. Some a-amino nitriles or the corresponding acylated derivatives can, furthermore, decompose into imines and cyanide if reaction temperatures are too high or if the bases used are too strong (Scheme 7.11). 

In order to broaden the scope we also examined [30] a combination of lipase-catalyzed acylation with penicillin acylase-catalyzed hydrolysis (deacylation). Good results (high enantioselectivity in the acylation and smooth deacylation) were obtained, with a broad range of both aliphatic amines and amines containing an aromatic moiety, using pyridylacetic acid ester as the acyl donor (Fig. 9.21). 

Aliphatic and alicyclic carbamates are nitrated smoothly and in excellent yields by a nitric acid-acetic anhydride mixture (4). Similarity, we have found that treating an acyl aliphatic amine and a urethane with one equivalent of nitronium tetrafluoroborate in acetonitrile at —30° C. gave the corresponding N-nitro derivatives in good to excellent yields. However, diacylamines are more difficult to nitrate, and Kauffman and Burger (9) have reported that nitrating succinimide required 13 hours... 

---