Alignment considerations

Kertesz, V. and Van Berkel, G.J., Scanning and surface alignment considerations in chemical imaging with desorption electrospray mass spectrometry, Anal. Chem., 80(4), 1027, 2008. 

Difficult to lubricate, minimum sizes available, special alignment considerations... 

Because of the rotation of the N—N bond, X-500 is considerably more flexible than the polyamides discussed above. A higher polymer volume fraction is required for an anisotropic phase to appear. In solution, the X-500 polymer is not anisotropic at rest but becomes so when sheared. The characteristic viscosity anomaly which occurs at the onset of Hquid crystal formation appears only at higher shear rates for X-500. The critical volume fraction ( ) shifts to lower polymer concentrations under conditions of greater shear (32). The mechanical orientation that is necessary for Hquid crystal formation must occur during the spinning process which enhances the alignment of the macromolecules. 

The formation of a fibrillar structure in TLCP blends makes the mechanical properties of this kind of composites similar to those of conventional fiber reinforced thermoplastics [11,26]. However, because the molecular orientation and fibrillation of TLCPs are generally flow-induced, the formation, distribution, and alignment of these droplets and fibers are considerably more processing-dependent. We do not know ... 

---