Aldehydes modifier effect

The use of both types of modifier to influence the selectivity of heterogeneous catalysts is not new. It has long been known, for example, that modifiers can have a powerful selectivity-enhancing effect in catalytic hydrogenation the Rosenmund reduction of acid chlorides to aldehydes is an early example of this. Another well-known modifier effect is rate and selectivity enhancement by bismuth in precious metal-catalyzed oxidations (Section 9.3). We feel, however, that the enormous po-... 

The search for catalyst systems which could effect the 0x0 reaction under milder conditions and produce higher yields of the desired aldehyde resulted in processes utilizing rhodium. Oxo capacity built since the mid-1970s, both in the United States and elsewhere, has largely employed tertiary phosphine-modified rhodium catalysts. For example, over 50% of the world s butyraldehyde (qv) is produced by the LP Oxo process, technology Hcensed by Union Carbide Corporation and Davy Process Technology. 

The y-keto nitriles shown in Table I were prepared by the cyanide-catalyzed procedure described here. This procedure is generally applicable to the synthesis of y-diketones, y-keto esters, and other y-keto nitriles. However, the addition of 2-furancarboxaldehyde is more difficult, and a somewhat modified procedure should be employed. Although the cyanide-catalyzed reaction is generally limited to aromatic and heterocyclic aldehydes, the addition of aliphatic aldehydes to various Michael acceptors may be accomplished in the presence of thioazolium ions, which are also effective catalysts for the additions. 

Selective Reactions on Modified Metal Surfaces the Ligand Effect Hydrogenation of a- Unsaturated Aldehydes... 

Under relatively mild conditions the Ru/C catalyst poisoned with Sn (lines 1 and 2), the Ir/C catalyst (lines 14 and 15), and the Raney-cobalt catalyst modified with CoCl2 (line 19) seem likely systems to try when initiating a search for an effective method for selectively hydrogenating the C=0 bond in an a, 3-unsaturated aldehyde. 

Thus, various kinds of bases are effective in inducing the Henry reaction. The choice of base and solvent is not crucial to carry out the Henry reaction of simple nitroalkanes with aldehydes, as summarized in Table 3.1. In general, sterically hindered carbonyl or nitro compounds are less reactive not to give the desired nitro-aldol products in good yield. In such cases, self-condensation of the carbonyl compound is a serious side-reaction. Several modified procedures for the Henry reaction have been developed. 

The coupling of the aryl aldehyde 84 and the a-iodoenone 85 was effected by a modified Ullmann reaction (83 %, Scheme 3.16) [42], The resulting arylation... 

The ejfect of water on the conversion and selectivity of cohalt-catalyzed hydroformylations has long been noticed in industry [7,85,86], A systematic study [87] of this effect in hydroformylation of 1-octene with [Co2(CO)s] with and without P Bu3 revealed that addition of water, and especially when it formed a separate aqueous phase, significantly inaeased the hydrogenation activity of the phosphine-modified catalyst Under the same reaction conditions (190 °C, 56 bar CO H2 1 1, P Co 3 1), approximately 40 % nonanols were formed instead of 5 % observed with water-free solutions. No clear explanation could be given for this phenomenon, although the possible participation of water itself in the hydroformylation reaction through the water gas shift was mentioned. It was also established, that the [Co2(CO)g]-catalyzed hydroformylation was severly retarded in the presence of water. Under the conditions above, 95 % conversion was observed in 15 hour with no added water, while only 10 % conversion to aldehydes (no alcohols) was found in an aqueous/organic biphasic reaction. 

Another a, i-unsaturated aldehyde analyzed is cinnamaldehyde. Its liquid-phase hydrogenation has been studied in our research group [20, 51, 94], using Pt, Ni and Cu-based tin-modified hi- and organobimetaUic catalysts (in all cases with Si02 as support). The catalytic results obtained showed that in aU cases there was a marked promoting effect of Sn on the selectivity to cinnamic alcohol (UOL). The specific modification of the monometallic systems due to Sn addition from the application of SOMC/M markedly increases the selectivity to UOL, especially in the case of Ni, where it goes from zero selectivity for the monometallic to 25% for the NiSn catalyst. Pt-based systems modified by Sn yield the best Suol values. 

---