Acylation diastereoselective

There has been recent interest in naphtho-fused dithiepines as chiral acyl anion equivalents, particularly since the starting dithiol 128 can be obtained in enan-tiomerically pure form (89TL2575). This is transformed using standard methods into the dithiepine 129, but showed only moderate diastereoselectivity in its addition to carbonyl compounds. On the other hand, as we have seen previously for other systems, formation of the 2-acyl compound 130 and reduction or addition of a Grignard reagent gave the products 131 with much better stereoselectivity (91JOC4467). 

In accord with the Felkin-Anh model, a-chiral ketones react more diastereoselectively than the corresponding aldehydes. Increasing steric demand of the acyl substituent increases the Cram selectivity. Due to the size of the acyl substituent, the incoming nucleophile is pushed towards the stereogenic center and therefore the diastereoface selection becomes more effective (see also Section 1.3.1.1.). Thus, addition of methyllithium to 4-methyl-4-phenyl-3-hexanonc (15) proceeds with higher diastercoselectivity than the addition of ethyllithium to 3-methyl-3-phenyl-2-pen-tanone (14)32. 

Besides 1,3-oxathianes, the 1,3-dithiane 1-oxide moiety can be used for directing the nucleophilic addition of an organometallic reagent to a carbonyl group in a diastereoselective manner. The addition of methylmagnesium iodide to the 2-acyl-l,3-dithiane 1-oxide 23A leads exclusively to the diastereomer which is formed by Re-side attack. On the other hand, addition... 

Conducting the aldol reaction at temperatures below —78 "C increases the diastereoselectivity, but at the cost of reduced yields45. Transmetalation of the lithium enolate 2 a by treatment with diethylaluminum chloride generated an enolate species that provided high yields of aldol products, however, the diastereoselectivity was as low as that of the lithium species45. Pre treatment of the lithium enolate 2a with tin(II) chloride, zinc(II) chloride, or boron trifluoridc suppressed the aldol reaction and the starting iron-acyl complex was recovered. 

The a-alkoxy iron-acyl complex 5 may be deprotonated to generate the lithium enolate 6, which undergoes a highly diastereoselective aldol reaction with acetone to generate the adduct 7 as the major product. Deprotonation of acetone by 6 is believed to be a competing reaction 30% of the starting complex 5 is found in the product mixture48 40. 

The diastereoselectivity of this reaction contrasts dramatically with the generally low selectiv-ities observed for aldol reactions of lithium enolates of iron acyls. It has been suggested thal this enolate exists as a chelated species48 the major diastereomer produced is consistent with the transition state E which embodies the usual antiperiplanar enolate geometry. 

Amidoalkylation of silyl enol ethers with /V-acyliiiiiiiium ions containing camphanoyl-derived acyl functions (see Appendix) as the chiral auxiliary leads to optically active 2-substituted piperidine derivatives with moderate to high diastereoselectivity, depending on the chiral auxiliary and the cnol ether82 99. The auxiliary is removed by hydrolysis with base or acid. 

The anions derived from racemic alkyl and benzyl tert-butyl sulfoxides undergo 1,4-addition to a,/J-unsaturated esters to give adducts with high product diastereoselection (>5 1)10,11. Alkyl 4-methylphenyl sulfoxides were found to be less diastereoselective. In the case of 2-methyl-2-(methylsulfinyl)propanc the highly hindered 2,6-di-rer7-butyl-4-methylphenyl ester was required to prevent a competing acylation reaction. 

Radical cascades that feature a 7-exo acyl radical cyclization followed by a 6-exo or 5-exo alkyl radical cyclization proceed with very good yields and diastereoselectivities. Two examples are shown in Reaction (80), where treatment of 100 with E3B, air, and (TMS)3SiH provided the tricycle 101 in excellent yields as a single diastereomer. Interestingly, the bulky silyl ether moiety is not required to achieve stereoselectivity in this process. 

Unsaturated acyl derivatives of oxazolidinones can be used as acceptors, and these reactions are enantioselective in the presence of chiral to-oxazoline catalysts.321 Silyl ketene acetals of thiol esters are good reactants and the stereochemistry depends on the ketene acetal configuration. The Z-isomer gives higher diastereoselectivity than the Zf-isomer. 

Seebach and Brenner have found that titanium enolates of acyl-oxazolidinones are added to aliphatic and aromatic nitroalkenes in high diastereoselectivity and in good yield. The effect of bases on diastereoselectivity is shown in Eq. 4.59. Hydrogenation of the nitro products yields y-lactams, which can be transformed into y-amino acids. The configuration of the products is assigned by comparison with literature data or X-ray crystal-structure analysis. 

Addition of A-mesityl benzimidazolyl carbene 720 to an a,/3-unsaturated aldehyde generates a homoenolate intermediate that undergoes an addition/acylation sequence with azomethine imine 719 to afford (3R, 5S, 6S )-177-pyrazolo[l,2- ]pyridazine-l,8(5//)-diones 721 with excellent diastereoselectivity. Compound 721 (Ar = R = Ph) treated with sodium hydoxide in methanol or benzylamine provided nearly quantitatively, ring-opened products 722a and 722b, respectively (Scheme 116) <2007JA5334>. 

Rhodium complexes catalyze 1,2-addition of main group metal compounds to aldimines as well. Table 5 summarizes the reported methods. Electron-withdrawing substituents such as sulfonyl and acyl groups on the imino nitrogen atom are important to obtain sufficiently high reactivity. Asymmetric synthesis (diastereoselective and enantioselective) has also been accomplished. 

Usually, (Z)-boron enolates can be prepared by treating /V-acyl oxazolidones with di-K-butylboron triflate and triethylamine in CH2CI2 at 78°C, and the enolate then prepared can easily undergo aldol reaction at this temperature to give a, vy -aldol product with more than 99% diastereoselectivity (Scheme 3-4). In this example, the boron counterion plays an important role in the stereoselective aldol reaction. Triethylamine is more effective than di-wo-propylethyl amine in the enolization step. Changing boron to lithium leads to a drop in stereoselectivity. 

Diastereoselective synthesis of lactones.1 Acylation of the enolate (LDA) of the vinylogous urethane (1) results in a product (2) that on reduction with LiBH[CH(CH3)C2H5]3 (3) forms the anft-lactone (4) exclusively (equation I). This two-step synthesis of lactones is the equilvalent of an aldol condensation between... 

---