Acyl triflates, acylation with

Chiral 2-oxazolidones are useful recyclable auxiliaries for carboxylic acids in highly enantioselective aldol type reactions via the boron enolates derived from N-propionyl-2-oxazolidones (D.A. Evans, 1981). Two reagents exhibiting opposite enantioselectivity ate prepared from (S)-valinol and from (lS,2R)-norephedrine by cyclization with COClj or diethyl carbonate and subsequent lithiation and acylation with propionyl chloride at — 78°C. En-olization with dibutylboryl triflate forms the (Z)-enolates (>99% Z) which react with aldehydes at low temperature. The pure (2S,3R) and (2R,3S) acids or methyl esters are isolated in a 70% yield after mild solvolysis. 

Triflates of boron, aluminum, and gallium were found to be efficient catalysts in Friedel-Crafts acylations.46 However, these are water-sensitive materials and were required to be used in equimolar quantities to be effective. More recently various water-tolerant and recyclable triflate salts, which were also tested in alkylation, were found to exhibit similar good characteristics in Friedel-Crafts acylations. Although benzene cannot be acylated, Sc triflate,47 48 lanthanum triflates,48-51 and Hf triflate52 usually give high yields of aryl ketones in acylation with acid anhydrides. In many cases, Li perchlorate was found to accelerate the reactions.48 52... 

Alkynes are readily acylated with acid chlorides under Friedel-Crafts conditions to form, in most cases, fram-p-chlorovinyl ketones through the corresponding vinyl cation intermediate [Eq. (8.16)]. The first study in 1935 reported low yields.11 Later in acylations with acyl triflates, p-keto vinyl triflates were obtained in satisfactory yields.123 When aroyl derivatives are used, the intermediate can undergo cyclization to form indenones. Chlorovinyl ketones formed from terminal alkynes may also react further losing hydrogen chloride to yield conjugated acetylenic ketones 11,13... 

The carbonylation of aryl iodide in the presence of terminal alkynes affords acyl alkynes. Bidentate ligands such as DPPF give good results [241]. When PI13P is used, phenylacetylene is mainly converted to diphenylacetylene. The alkynyl ketones 488 are prepared by the reaction of the alkenyl triflate 487 with phenylacetylene and CO [242],... 

Against this background it is important that—quite fitting in this still new millennium— the first catalytic Friedel-Crafts acylations of (still relatively electron-rich) aromatic compounds were reported (Figure 5.35). Trifluoromethane sulfonates ( triflates ) of rare-earth metals, e. g., scandium(III)triflate, accomplish Friedel-Crafts acylations with amounts of as little as 1 mole percent. Something similar is true of the tris(trifluoromethanesulfonyl)-methides ( triflides ) of rare-earth metals. Unlike conventional Lewis acids, the cited rare-earth metal salts can form 1 1 complexes with the ketone produced, but these are so unstable that the Lewis acid can re-enter the reaction. Whether this works analogously for the third catalytic system of Figure 5.35 is unclear. 

The acylation of the organolithium 126 has been studied with the lactone 145 affording stereoselectively the /J-lactol 146 (Scheme 41). The C-disaccharide 149 has been prepared by reaction of compound 148 (prepared from the same starting material 126 and the triflate 147), with 145 followed by reduction and final dehydroxylation153. 

Thio- and selenoacetals and esters are excellent substrates for mild Friedel-Crafts reactions, because of the affinity of sulfur and selenium for copper (Sch. 23). Anisole was readily acylated with methylselenoesters 94 at room temperature with activation by CuOTf to affordpnra-substituted (> 95 %) derivatives 95 [50,51]. Mercury(II) and copper(II) salts, which were effective for the activation of selenyl esters for reaction with alcohols, amines, and water, were not effective for the Friedel-Crafts reaction. Aromatic heterocycles 96 could be acylated in high yields, and the alkylation product 100 was obtained from dibutylthioacetal 99 and anisole. Vedejs has utilized this methodology in the cyclization of 101 to afford 102 in 77 % yield [52]. This intramolecular variant did not require the use of the more reactive bis copper triflate-benzene complex. 

Imidazoles have been N-acylated by isocyanates (at elevated tempera-tures) " (Scheme 21), acid halides, and alkyl chlorocarbonates, but 2-methylimidazole would not react with formamide and phosphoryl chloride. Trifluoromethylsulfonation forms the imidazolide which is a convenient reagent for the introduction of the triflate group. ° With highly basic I-substituted imidazoles, acetyl halides form the 1-acetyl-... 

Anisole can be acylated with acetic anhydride in 99% yield (6.12). Yttterbium triflate can also be used. The yields are low when there is no activating group in the ring. The rate is accelerated by the addition of lithium perchlorate.56 Acylation of alcohols works well with 1 mole% of scandium triflate as a catalyst (6.13).57 The less toxic toluene has also been used as the solvent in such acylations. The... 

TRIOXAPENTADECANE (112-73-2) C12H26O3 Combustible liquid (flash point 245°F/118°C oc autoignition temp 590°F/310°C Fire Rating 1). Reacts violently with oxidizers, permanganates, peroxides and hydroperoxides, ammonium persulfate, bromine dioxide, sulfuric acid, nitric acid, perchloric acid, and other strong acids Lewis acids including aluminum chloride, boron trifluoride, iron(III) chloride, niobium pentachloride, and ytterbium(III) triflate. Incompatible with acyl halides. 

Among various strategies towards ulosonic acids various acylation reactions are often used. They involve alditol derivatives as convenient substrates, and diverse acyl anion equivalents. Here belongs the synthesis of KDO, developed by Shiba et al. [84], By reaction of the triflate 67 with the lithiated 68, eight carbon atoms compound 69 was obtained (Scheme 17). Removal of O-acetyl residue with subsequent NBS promoted oxidative hydrolysis of the dithioacetal moiety resulted in the formation of KDO derivative 70. 

Displacement on the triflate 197 with oxygen nucleophiles allows immediate access to (7 )-malic acid derivatives. Potassium propionate or potassium benzoate cleanly inverts the stereocenter of 197b to give 0-acyl (i )-malates 200 in moderate yield [74]. 

Synthesis of left-hand segment began with 7-benzyloxyindole 197. A Vilsmeier-Haack formylation followed by condensation afforded nitroalkene 198. Reduction, acylation with succinic anhydride, and subsequent Bischler-Napieralski cyclization provided dihydro-p-carboline 199. Noyori asymmetric reduction of 199, further treatment with A-iodosuccinimide, followed by activation with silver triflate in the presence of dimethoxy-N,N-diallylaniline furnished the desired coupling product 200. Subsequent saponification and cyclization via a ketene intermediate gave the rearrangement precursor 201. Oxidative skeletal rearrangement initiated by m-CPBA followed by removal of the Fmoc group and conversion of the aniline to the hydrazine furnished Fischer indole precursor 202 (Scheme 35). 

One routine method for the functionalization of quinolines is the addition of substituents to the 2-position. Further advances in the catalytic, enantioselcctive Reissert-type reaction were reported. Quinoline 63 was treated with 2-furoyl chloride and TMSCN in the presence of Lewis acid-Lewis base bifunctional catalyst 64 followed by reduction of the corresponding enamine to afford quinoline 65 in 93% ee. Quinoline 65 was subsequently converted to (-)-L-689,560, a potent NMDA receptor antagonist <01JA6801>. Additions of ally.silanes to quinolines acylated with chloroformate esters and catalyzed by various triflate salts were reported <01T109>. 

Indoles with carbocyclic halogen or triflate substituents are potential starting materials for vinylation, arylation and acylation via palladium-catalysed pro-cesses[l]. Indolylstannanes. indolylzinc halides and indolylboronic acids are also potential reactants. The principal type of substitution which is excluded from such coupling reactions is alkylation, since saturated alkyl groups tend to give elimination products in Pd-catalysed processes. 

---