Acid chlorides spectroscopic analysis

The acylation of enamines derived from cyclic ketones, which can lead to the acyl ketone or ring expansion (692-694), was studied by NMR and mass spectroscopic analysis of the products (695,696). In a comparative study of the rates of diphenylketene addition to olefins, a pronounced activation was observed in enamines (697). Enamine N- and C-acylation products were obtained from reactions of Schiff s bases (698), vinylogous urethanes (699), cyanamides (699), amides (670,700), and 2-benzylidene-3-methylbenzothiazoline (672) with acid chlorides, anhydrides, and dithio-esters (699). 

Synthesis of Siloxane-Polyimide Elastoplastics. In a typical polymerization, a 5-L, three-neck, round-bottom flask equipped with an overhead mechanical stirrer, a Dean-Stark trap with condenser and a nitrogen inlet, and a thermometer was charged with 484.00 g (0.2406 mol) of D2o-DiSiAn, 41.61 g (0.431 mol) of mPD, 19.52 g (3 wt %) of 2-hydroxypyridine, and 2 L of o-dichlorobenzene. The mixture was warmed to 100 °C for 1 h to dissolve the monomers and the catalyst. The polyamic acids precipitated and then redissolved when the mixture was warmed to 150 °C for 2 h. To the oligomer solution was added 99.13 g of BPADA dissolved in 200 mL of o-dichlorobenzene. The mixture was maintained at 150 °C for an additional 2-h period to ensure incorporation of the dianhydride and then warmed to reflux. After approximately 100 mL of a solvent-water mixture had been removed, the solution was maintained at 180 °C for 40 h. The mixture was cooled to room temperature and diluted with 1 L of methylene chloride. Polymer was isolated from the solution by a slow addition of the polymer solution to 4 L of methanol. The resulting slurry was filtered, and the polymer was redissolved in 4 L of methylene chloride, extracted three times with 2 N aqueous HCl to remove catalyst, washed with water, dried with magnesium sulfate, reprecipitated into methanol as before, filtered, and dried in vacuo at 100 °C to obtain 522 g (85%) of a rubbery material with an IV of 0.50 dL/g. IR, NMR, and Si NMR spectroscopic analysis indicated the absence of amic acid functionalities that could be present if imidization is incomplete. 

Although acetyl chloride is a convenient reagent for deterrnination of hydroxyl groups, spectroscopic methods have largely replaced this appHcation in organic chemical analysis. Acetyl chloride does form derivatives of phenols, uncompHcated by the presence of strong acid catalysts, however, and it finds some use in acetylating primary and secondary amines. 

Mesoionic 4-amino-l,2,3,5-thiatriazoles constitute the only class of mesoionic 1,2,3,5-thiatriazoles known. They are prepared by the reaction of l-amino-l-methyl-3-phenylguanidine with approximately 2 equivalents of thionyl chloride with pyridine as solvent (88ACS(B)63>. They are obtained as the yellow 1 1 pyridine complexes (17). The dark-violet mesoionic 1,2,3,5-thiatriazole (18) was liberated on treatment with aqueous potassium carbonate (Scheme 3). The structure is established on the basis of elemental analysis and spectroscopic data. In particular, the IR spectrum is devoid of NH absorptions. Compound (18) exhibits a long-wavelength absorption at 463 nm in methanol. When mixed with an equivalent amount of pyridinium chloride, complex (17) is formed and the absorption shifts to 350 mn. The mesoionic thiatriazoles are sensitive towards mineral acids and aqueous base and although reaction takes place with 1,3-dipolarophiles such as dimethyl acetylene-dicarboxylate, a mixture of products were obtained which were not identified. 

To obtain more information on the nature of the quasiphosphonium intermediates involved in these systems we have studied the reactions gf sterically hindered neopentyl esters by means of 1P nmr spectroscopy. Trineopentyl phosphite and a-bromoacetophenone gave rise to a peak at +41 ppm due to the ketophosphonium intermediate 3 (R = Me.CCH, R = Ph X = Br ) within half an hour of mixingJthe reactants in acetone-dfi at 27 °C ( p nmr shifts are relative to 85% H-PO. down-field positive). Peaks due to the ketophospnonate 4 +19 ppm and the vinyl phosphate 7 (-7 ppm) were also observed (compound 4 and 7 have satisfactory elemental analysis and spectroscopic data ). The concentration of the intermediate reached a maximum after about two hours when it was precipitated from acetone solution by the addition of anhydrous ether to give white crystals of trineopentyloxy (phenacyl)phosphonium bromide, identified by elemental analysis and nmr spectroscopy ( XP 6+41, in CDCl ). When redissolved in acetone-dg, deuterochloroform, acetic acid, or acetic acid-acetone mixtures, the intermediate decomposed to yield keto-phosphonate 4 but none of the vinyl phosphate 6 (Perkow product). Nor was the course of reaction affected by the addition of chloride ion or of a-chloro-acetophenone in acetonitrile. 

The diester 23 was hydrolyzed to diacid 24, and then dehydrated to give anhydride 25. Subsequent reaction of this anhydride with amino amide 26 in acetonitrile gave two regioisomeric acid diamides 27 and 28 in the approximate ratio of 10 to 1. Pure 27 was isolated in 85% yield by heating the mixture in methylene chloride followed by extraction with 5% aqueous NaOH at room temperature. Treatment of 27 with 5% aqueous NaOH at 80 C then led to cyclization forming the desired imidazolinone 5. Its structure was confirmed by spectroscopic data and elemental analysis. 

---