Thermocompression Evaporators

The ideal mechanical power requirement of a thermocompression evaporator is given by the Carnot equation ... 

Thermocompression Evaporators Thermocompression-evap-orator calculations [Pridgeon, Chem. Metall. Eng., 28, 1109 (1923) Peter, Chimin Switzerland), 3, II4 (1949) Petzold, Chem. Ing. Tech., 22, 147 (1950) and Weimer, Dolf, and Austin, Chem. Eng. Prog., 76(11), 78 (1980)] are much the same as single-effect calculations with the added comphcation that the heat suppied to the evaporator from compressed vapor and other sources must exactly balance the heat requirements. Some knowledge of compressor efficiency is also required. Large axial-flow machines on the order of 236-mVs (500,000-ftVmin) capacity may have efficiencies of 80 to 85 percent. Efficiency drops to about 75 percent for a I4-mVs (30,000-ftVmin) centrifugal compressor. Steam-jet compressors have thermodynamic efficiencies on the order of only 25 to 30 percent. 

The two principal elements of evaporator control are evaporation rate a.ndproduct concentration. Evaporation rate in single- and multiple-effect evaporators is usually achieved by steam-flow control. Conventional-control instrumentation is used (see Sec. 22), with the added precaution that pressure drop across meter and control valve, which reduces temperature difference available for heat transfer, not be excessive when maximum capacity is desired. Capacity control of thermocompression evaporators depends on the type of compressor positive-displacement compressors can utilize speed control or variations in operating pressure level. Centrifugal machines normally utihze adjustable inlet-guide vanes. Steam jets may have an adjustable spindle in the high-pressure orifice or be arranged as multiple jets that can individually be cut out of the system. 

---