Tergitol®

Acrolein is produced according to the specifications in Table 3. Acetaldehyde and acetone are the principal carbonyl impurities in freshly distilled acrolein. Acrolein dimer accumulates at 0.50% in 30 days at 25°C. Analysis by two gas chromatographic methods with thermal conductivity detectors can determine all significant impurities in acrolein. The analysis with Porapak Q, 175—300 p.m (50—80 mesh), programmed from 60 to 250°C at 10°C/min, does not separate acetone, propionaldehyde, and propylene oxide from acrolein. These separations are made with 20% Tergitol E-35 on 250—350 p.m (45—60 mesh) Chromosorb W, kept at 40°C until acrolein elutes and then programmed rapidly to 190°C to elute the remaining components. 

Chemical Designations - Synonyms Ethoxylated dodecyl alcohol, Ethoxylated lauryl alcohol, Poly(oxyethyl)dodecyl ether, Poly(oxyethyl) lauryl ether, Tergitol Nonionic TMN Chemical Formula CijHu0(CH2CH20) CHi CH OH n=6-10 (average). 

The yield of luminescence activity is increased by including CTAB, Tergitol 7 (a sulfate detergent), or p-toluenesulfonyl chloride to various extents. 

This behavior shows that the dimensions of these polymers are independent of pH, ionic strength (in the ranges studied) and presence or absence of Tergitol or polyethyleneoxide. This result is of considerable help in interpretation of GPC behavior since in the absence of polymer-glass substrate interactions, the molecular weight calibration curves (log MW vs. elution volume) should be independent of pH, ionic strength or the two nonionic surfactants investigated. 

Figure 1. Intrinsic viscosities for nonionic polyacrylamides in water and aqueous solutions of various pH and ionic strength ((%, 4) water (, O, m) aqueous solutions (pH range 2,5 7.0 and ionic strength range 0,013-. 503) containing a nonionic surfactant (either Tergitol or polyethylene oxide = 300,000))...

In the presence of polyethylene oxide MW 300,000 at a concentration of 0.025 g liter , variations in pH and ionic strength have no effect on elution volumes and a single calibration curve is obtained as shown in Figure 4 and Table II. This behavior presumably also results from modification of the glass surface by the polyethylene oxide surfactant, but in this case charge effects appear to be completely suppressed and the effective pore diameter and volume reduced. Such an interpretation is also in accord with the fact that the elution voliomes are lower with polyethylene oxide than with Tergitol, since Tergitol is a much smaller molecule than the polyethylene oxide. 

Molecular Weight Calculations on Nonionic PAM Standards - Tergitol in Mobile Phase (no Polyethylene Oxide)... 

For example, MSU-1 prepared using Tergitol is a disordered hexagonal mesoporous (25-48 A) silica. More recently, triblock copolymers based on ethylene oxide (EO) and propylene oxide (PO) have been used to make well-ordered mesoporous silicas having ID channels with pore sizes in the range of 50-300A... 

Terephthaloyl chlorides (TCL), 29 715 polycondensation, 7 635 polymers derived from, 23 730 TERFENOL-D (terbium dysprosium iron alloy), 22 714 TERGITOL, 2 43... 

Surfactants are major compounds that reach the subsurface alone or accompanying other contaminants. Their effect depends highly on the solution chemishy. For example. Park and Bielefeldt (2003) report the partitioning of Tergitol a nonionic surfactant, and pentachlorophenol (PCP), from nonaqueous phase hquid (NAPL) to an aqueous solution. Enhanced PCP dissolution into water from the NAPL was... 

---