Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Split tear test-piece

Figure 5.2 DUferent types of tear test-pieee geometry (a) trouser, (b) pure shear, (c) angle and (d) split tear test-pieces. Figure 5.2 DUferent types of tear test-pieee geometry (a) trouser, (b) pure shear, (c) angle and (d) split tear test-pieces.
For the split tear test-piece, the tearing energy is given by ... [Pg.165]

Figure 5.9 Photos showing split tear test-piece to simulate crack propagation in the direction of molecular orientation in knotty tearing. Figure 5.9 Photos showing split tear test-piece to simulate crack propagation in the direction of molecular orientation in knotty tearing.
Crack growth measurements using the split tear test-piece provide further experimental evidence that tearing energy is a measure of true crack growth... [Pg.191]

The tearing energy of a split tear test-piece is computed using Equation (5.7), discussed in Section 5.2. [Pg.192]

Figure 5.28 shows the crack growth characteristics of unfilled NR obtained from split tear test-pieces and compared with the results published by Lake et The results are presented in the form of crack growth per cycle... [Pg.192]

Split-tear test pieces were prepared by die stamping on a thin flat sheet of vulcanized rubber of uniform thickness. The test piece was clamped by a grip, and a dead load apphed to the other end of the test piece via a fiictionless pulley. A dead load, which... [Pg.69]

Azemi, S. and Bijarimi, M. P. (2004). Cyclic crack growth measurement using split-tear test piece. J. Rubb. Res. [Pg.143]

See other pages where Split tear test-piece is mentioned: [Pg.165]    [Pg.171]    [Pg.172]    [Pg.173]    [Pg.174]    [Pg.174]    [Pg.180]    [Pg.180]    [Pg.180]    [Pg.191]    [Pg.192]    [Pg.67]    [Pg.68]    [Pg.69]   
See also in sourсe #XX -- [ Pg.141 ]



SEARCH



Pieces

Split tests

Tear test

Tears

Test pieces

© 2024 chempedia.info