Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

SMSI—See Strong metal-support interaction

Small metal particles are frequently expected (however, the evidence is sometimes questionable) to experience an electron transfer with the carrier, which modifies the adsorption and catalytic properties of the metal particles [sometimes called the Schwab effect (108-116)]. In other cases, by special conditions under preparations of the catalysts, a so-called strong metal support interaction effect (SMSI) (117-121) was evoked. In particular, with zeolites as carriers, there are pieces of experimental evidence reported (115, 116) in support of the existence of such transfer (for remarks on those conclusions, see 122, 123). [Pg.160]

Fig. 4.38. The effects of various pretreatments (oxidative and reductive) on CO oxidation on a 40-nm Pt/ceria model catalyst prepared by colloidal lithography as measured by the temperature of 50% of CO conversion and the apparent activation energy from the Arrhenius plot. CO reduction was made in 0.5% CO for Ih at 573K, H2 oxidation (a-treatment) was done at a = Ph2/(.Ph.2 + P02) = 0.33 at 573 K for 1 h, and finally /3 = CO oxidation (/3-treatment) was done in the O-rich regime (oxidative conditions), /3 = Pco/ Pco + P02) = 0.2 with 0.3% CO and 1.2% O2 at temperatures between 300 and 673 K. It is seen that reduction leads to a lower Tbo and activation energy, while sustained CO oxidation leads to an increase of the activation energy, which is not recovered by reductive treatments. The latter is explained in terms of strong-metal-support interactions (SMSI) and particle reshaping (see text)... Fig. 4.38. The effects of various pretreatments (oxidative and reductive) on CO oxidation on a 40-nm Pt/ceria model catalyst prepared by colloidal lithography as measured by the temperature of 50% of CO conversion and the apparent activation energy from the Arrhenius plot. CO reduction was made in 0.5% CO for Ih at 573K, H2 oxidation (a-treatment) was done at a = Ph2/(.Ph.2 + P02) = 0.33 at 573 K for 1 h, and finally /3 = CO oxidation (/3-treatment) was done in the O-rich regime (oxidative conditions), /3 = Pco/ Pco + P02) = 0.2 with 0.3% CO and 1.2% O2 at temperatures between 300 and 673 K. It is seen that reduction leads to a lower Tbo and activation energy, while sustained CO oxidation leads to an increase of the activation energy, which is not recovered by reductive treatments. The latter is explained in terms of strong-metal-support interactions (SMSI) and particle reshaping (see text)...
The reducibility of platinum should be affected both by SOOI effect (see above) and strong metal-support interaction (SMSI) between platinum and transition metal oxide monolayer. Both mentioned effects were observed by means of temperature-programmed techniques. TPR investigations put in evidence that the reducibility of platinum strongly depended on the type of primary carrier as well as on the type of transition metal monolayer. The results of TPR investigations are presented in Fig. 1 and Table 2. [Pg.790]

Promotion of the Rates of C— O Bond Hydrogenation by the Oxide-Metal Interface CO hydrogenation catalysis has benefited greatly from the rediscovery of the unique catalytic behavior of oxide-metal interfaces first observed by Schwab [92]. The effect is commonly referred to as strong metal-support interaction, or SMSI (see also reference [93]). Tauster et al. [94, 95] reported large enhancement... [Pg.491]


See other pages where SMSI—See Strong metal-support interaction is mentioned: [Pg.90]    [Pg.317]    [Pg.569]    [Pg.229]    [Pg.1498]    [Pg.1497]   


SEARCH



Metal support interaction

Strong interaction

Strong metal-support interaction SMSI)

Strong-metal-support Interactions

Support interaction

Supported interactions

© 2024 chempedia.info