Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Side reactions carbon-palladium bonds

As described in the preceding sections, many domino reactions start with the formation of vinyl palladium species, these being formed by an oxidative addition of vinylic halides or triflates to Pd°. On the other hand, such an intermediate can also be obtained from the addition of a nucleophile to a divalent palladium-coordinated allene. Usually, some oxidant must be added to regenerate Pd11 from Pd° in order to achieve a catalytic cycle. Lu and coworkers [182] have used a protonolysis reaction of the formed carbon-palladium bond in the presence of excess halide ions to regenerate Pd2+ species. Thus, reaction of 6/1-386 and acrolein in the presence of Pd2+ and LiBr gave mainly 6/1-388. In some reactions 6/1-389 was formed as a side product (Scheme 6/1.98). [Pg.421]

C.i.a. Sequential Hydroarylation (Hydroalkenylation)/Cyclization. Since the cis stereochemistry of addition pushes the substituents of the acetylenic moiety to the same side of the olefinic double bond, a cyclization reaction can follow the addition step when these substituents bear suitable nucleophilic and electrophilic centers, and the whole process resembles a valuable straightforward methodology for the preparation of cyclic compounds (Scheme 20). Cyclization can occur under hydroarylation(hydroalkenylation) conditions—either before or after the substitution of the carbon-hydrogen bond for the carbon-palladium bond—or by subjecting the isolated hydroarylation(hydroalkenylation) product to suitable reaction conditions. This strategy has been employed successfully to develop new routes to various heterocycles. [Pg.1345]

In the case of certain diolefins, the palladium-carbon sigma-bonded complexes can be isolated and the stereochemistry of the addition with a variety of nucleophiles is trans (4, 5, 6). The stereochemistry of the addition-elimination reactions in the case of the monoolefins, because of the instability of the intermediate sigma-bonded complex, is not clear. It has been argued (7, 8, 9) that the chelating diolefins are atypical, and the stereochemical results cannot be extended to monoolefins since approach of an external nucleophile from the cis side presents steric problems. The trans stereochemistry has also been attributed either to the inability of the chelating diolefins to rotate 90° from the position perpendicular to the square plane of the metal complex to a position which would favor cis addition by metal and a ligand attached to it (10), or to the fact that methanol (nucleophile) does not coordinate to the metal prior to addition (11). In the Wacker Process, the kinetics of oxidation of olefins suggest, but do not require, the cis hydroxypalladation of olefins (12,13,14). The acetoxypalladation of a simple monoolefin, cyclohexene, proceeds by trans addition (15, 16). [Pg.100]

The palladium-catalyzed hydrogenolysis of 2-butoxy-l,l-difluorocyclopropanes 3 resulted in the reductive cleavage of the cyclopropyl bond opposite to the electron-deficient carbon atom. Fluorine-hydrogen exchange in the product was observed as a side reaction. [Pg.2121]

Papers (4, 47, 48) demonstrate that, while the character of the carrier (silica gel, active carbon) of the active component has no pronounced influence on the process of hydrogenation, there are distinct differences in the effect of the active components themselves. Side reactions occurred on rhodium and palladium catalysts, while on platinum catalysts they could not be observed in most cases (migration of the double bond, cis-trans isomerization). These reactions occurred only if a sufficient amount of hydrogen was present in the reaction mixture (part of hydrogen is irreversibly consumed by hydrogenation). Neither the carrier alone nor the catalyst in an inert atmosphere provoked any side reactions, which shows that hydrogen in one of its forms participates directly in the isomerization process. [Pg.347]

While such a process had initially been observed as an undesired side-reaction in transformations where copper salts were employed as re-oxidants [13], Chemler demonstrated that various aminohalogenation reactions proceed in THF or acetonitrile in the presence of potassium carbonate as base [14]. These reactions employ palladium trifluoroacetate or palladium dibromide as catalyst source and require a moderate excess of the copper oxidant (3-4 equiv) giving moderate to excellent yields. However, they usually suffer from rather low selectivity, either in the initial aminopalladation or via subsequent rearrangement pathways to provide mixtures of pyrrolidines and piperazines (Scheme 4.2, Eq. (4.3)). A stoichiometric control reaction in the presence of palladium bromide led only to the Wacker cydization together with an alkene isomerization product, suggesting that the presence of copper(II) salts is crucial for the overall process. The exact role of the copper(II) salts has not yet been darified and palladium intermediates of different oxidation states may be involved in the final stage of carbon-halogen bond formation. [Pg.122]

Aryl, allyl, alkyl, alkynyl-palladium species being formed under the various conditions stated above might be subject of a reduction to yield a carbon-hydrogen bond. In some cases, reduction is a serious side-product in cross-coupling reactions. The reduction of allyl complexes has been discussed on page 800. [Pg.951]

Replacement of halides with deuterium gas in the presence of a surface catalyst is a less useful reaction, due mainly to the poor isotopic purity of the products. This reaction has been used, however, for the insertion of a deuterium atom at C-7 in various esters of 3j -hydroxy-A -steroids, since it gives less side products resulting from double bond migration. Thus, treatment of the 7a- or 7j5-bromo derivatives (206) with deuterium gas in the presence of 5% palladium-on-calcium carbonate, or Raney nickel catalyst, followed by alkaline hydrolysis, gives the corresponding 3j3-hydroxy-7( -di derivatives (207), the isotope content of which varies from 0.64 to 1.18 atoms of deuterium per mole. The isotope composition and the stereochemistry of the deuterium have not been rigorously established. [Pg.200]


See other pages where Side reactions carbon-palladium bonds is mentioned: [Pg.565]    [Pg.61]    [Pg.607]    [Pg.117]    [Pg.113]    [Pg.24]    [Pg.195]    [Pg.16]    [Pg.245]    [Pg.225]    [Pg.802]    [Pg.258]    [Pg.448]    [Pg.209]    [Pg.565]    [Pg.117]    [Pg.182]    [Pg.16]    [Pg.128]    [Pg.16]    [Pg.1335]    [Pg.16]    [Pg.268]    [Pg.671]    [Pg.238]    [Pg.847]    [Pg.262]    [Pg.1335]    [Pg.468]    [Pg.431]    [Pg.187]    [Pg.390]    [Pg.564]    [Pg.381]    [Pg.56]    [Pg.381]    [Pg.418]    [Pg.297]    [Pg.51]    [Pg.971]   
See also in sourсe #XX -- [ Pg.114 ]




SEARCH



Palladium bonding

Palladium carbonates

Side reactions 7-bonds

© 2024 chempedia.info