Process diagrams valve symbols

The symbols used to show the equipment, valves, instruments and control loops will depend on the practice of the particular design office. The equipment symbols are usually more detailed than those used for the process flow-sheet. A typical example of a P and I diagram is shown in Figure 5.25. 

Symbols and diagrams have been developed for most pieces of industrial equipment, process flows, and instrumentation. The symbols covered in this chapter include those typically used with valves, piping, tanks, pumps, compressors, steam turbines, motors, heat exchangers, cooling towers, furnaces, boilers, distillation columns, and reactors. Figure 7-6 shows many of the basic symbols for valves. 

The symbol used on a diagram for a plate column should indicate the type of tray used in the system bubble-cap, valve, or sieve. The first distillation column was invented in 1917. Today, a number of modifications allow modern process technicians to operate much more efficiently. The design, however, still includes the original still-on-top-of-a-still approach. The basic components of a plate distillation column are a feed line feed tray stripping section below the feed line enriching or rectifying section above the feed line overhead vapor outlet, side-stream outlet, and bottom outlet reboiler instrumentation for level, temperature, flow, pressure, and composition control outer shell and a top reflux line. 

Some symbols are common between plants, whereas others change depending on the company. In other words, two different symbols may be used to identify a centrifugal pump or a valve, for example. Some standardization of process symbols and diagrams is taking place, but the process technician must learn what symbols his or her employer uses. The symbols shown in this chapter reflect a wide variety of petrochemical and refinery operations. 

---