Probe marking data points

Important note By clicking the OK button, you will change the settings for all future plots. All plots In this session as well as plots In the future will mark the data points. If you do not want to make a setting permanent, you must change the setting back before you exit Probe... 

On the basis of the force-spectroscopy data, we calculated the average force of adhesion of the probe to the studied surface (data were averaged over the analyzed area) and the adhesion force at each point and maps of the adhesion-force distribution were plotted before and after the sample modification (Figs. 9.2c. and 9.2d, respectively). It has been established that, after marking, the average adhesion force has decreased by 5% as compared to the initial value (5.3 0.03 and 5.6 0.04 nN, respectively). The RMS error of the adhesion-force measurements calculated for each of 784 points resulted in a value no higher than 0.04 nN at a confidence interval of 95%. 

---