Print REACH

After processing the print, give it a short wash. Place the print in the Polytoner 1 30 for about 30 seconds. Move the print to a water bath and let it sit without any agitation. Toning comes up slowly. When the print reaches the desired color remove it from the water bath and wash normally. 

Precipita.tlon. An ink may also be caused to dry by precipitation of its binder rather than by evaporation of solvent. This can be accompHshed by a dding a diluent, such as water in the form of steam or humidity, to a hygroscopic solvent ink system, which causes the solubiHty of the resin in the ink film to decrease sharply and causes it to precipitate when its tolerance for the diluent is reached. Eurther drying is accompHshed by absorption of the solvents into the stock and then by evaporation. Another form of precipitation setting is the quick-set mechanism. This utilizes resins held in solution in a relatively poor solvent, by means of a small amount of an exceUent solvent (called a sweetener) blended with it. When the ink film is printed on the paper, an amount of the solvents is absorbed reducing the content of the sweetener solvent to a point which causes the resins to precipitate and the ink to set. 

The printing of newspapers is conducted at very high speeds, often reaching 3000 feet per miaute. AH three printing processes utilize similar quaHty newsptint which, essentiaHy, is made of groundwood or thermomechanical pulp. Presses are fed a continuous web of newsptint that unwiads from a feed roUer. Inks dry by absorption of Hquid iato the porosity of the substrate. Some evaporation of water ia a flexo pubHcation ink can accelerate the dryiag process. 

HS-GC methods have equally been used for chromatographic analysis of residual volatile substances in PS [219]. In particular, various methods have been described for the determination of styrene monomer in PS by solution headspace analysis [204,220]. Residual styrene monomer in PS granules can be determined in about 100 min in DMF solution using n-butylbenzene as an internal standard for this monomer solid headspace sampling is considerably less suitable as over 20 h are required to reach equilibrium [204]. Shanks [221] has determined residual styrene and butadiene in polymers with an analytical sensitivity of 0.05 to 5 ppm by SHS analysis of polymer solutions. The method development for determination of residual styrene monomer in PS samples and of residual solvent (toluene) in a printed laminated plastic film by HS-GC was illustrated [207], Less volatile monomers such as styrene (b.p. 145 °C) and 2-ethylhexyl acrylate (b.p. 214 °C) may not be determined using headspace techniques with the same sensitivities realised for more volatile monomers. Steichen [216] has reported a 600-fold increase in headspace sensitivity for the analysis of residual 2-ethylhexyl acrylate by adding water to the solution in dimethylacetamide. 

Table 1 Substances appearing as components of inks or glues and found in the Danish printing industry. All substances meet one or more of the criteria (e.g. CMR, EDS) for the REACH Annex XIV candidate list...

---